Question about 1999 Chrysler Cirrus

1 Answer

1999 Cirrus, ABS, 4 disks, driver rear brake is stuck. It has been ok during 30 degrees or colder, but not in 50s and stuck again. I replaced the caliper tonight and it still does it. Is there something under the hood that could be the problem?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,011 Answers

Very common problem on these car replace the brake hose at the caliper.even thow you can get fluid out it wont relief the presure.

Posted on Jan 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Chrysler Cirrus LXi 3.6 4 door sedan 4 Disk


check the level of dot 3 oil in the reserves...remember you replaced the lines and air has gotten into it- ti may take a bit to fill caliper..
if this doesnt work there might be a problem with the brakes fluid dispersion- it regulates the amount of fluid to each wheel...

Sep 03, 2013 | 2000 Chrysler Cirrus

1 Answer

How to get bus ac colder


to me 60 degrees is cool .R134 not going to get but so cold.40 and 50s way too cool need wear jacket.only thing will get that cold is refrigerator gas wont work in automobiles.

Jul 05, 2013 | Cars & Trucks

1 Answer

Do a 2000 chrysler cirrus(v6) have brake drums for a rear brake??


the car came with both disk and drum setups on the rear, it depends on what was ordered, the most common is the front disk and rear drum, but many did have the 4 wheel disk setup.

Oct 26, 2010 | 2000 Chrysler Cirrus

1 Answer

1999 4x4 dodge ram abs light &brake light has been on about a week. brake fluid &brakes are good. any suggestions


If you lose the speedometer, replace the rear differential speed sensor on top. If the speedo is ok, then it's your ABS pump/solenoid unit in the engine compartment left rear side. Most of the 99's have only the rear ABS, not front so don't look at the front brakes for the issue.

Aug 16, 2010 | 1999 Dodge Ram

1 Answer

Speedometer and taq not working. and abs light came on at same time for a 1999 ford windstar 3.0. all stoped working and the abs light came on at same time.


If your speedometer is not working, that means your Vehicle Speed Sensor or VSS for short, needs to be replaced. The ABS light means your ABS sensors need to be replaced. There are 4 ABS sensors: Front driver's side, Rear driver's side, Front passengers side, and Rear passenger's side. Once you replace your VSS, it will start communicating with your transmission again, and the speedometer will kick in. Hope this helps.

Jan 25, 2010 | 1999 Ford Windstar

1 Answer

Picture of 1999 Chrysler Cirrus rear disc parking brake system. Is parking brake operated by rear caliper? If so, is there a special procedure for moving the piston inward when replacing the brake pads?


Parking brake is operated by a cable and not the caliper. Your car has disc brake pads for squeezing the rotor to stop, the parking brake has drum type brake shoes that push out on the inside of the rotor. Changing the disc pads only requires squeezing the piston back in like usual.

Nov 06, 2009 | 1999 Chrysler Cirrus

2 Answers

1997 ford f-150 flashing abs light (flashes 15 times then stops solid and then flashes again 15 times) rear brakes shoes are at 50% no broken parts inside drum area. did notice that somtimes i would come...


Does your speedometer work ok? There is a sensor on top of your rear differential that provides a signal to both the abs and the computer(speedometer uses the signal from the computer) This sensor goes out pretty common.

Jun 08, 2009 | 1999 Ford F150 Regular Cab

2 Answers

1999 f150 anti lock brakes


John, My 99 F150 had an abs light on and I found the right side front wheel sensor wire had fallen off of the inner fender mount and burned the insulation and grounded the wires together, I taped up the wires and tied it up and the light went out. Your ABS module is located directly beneath your air cleaner next to and just above the steering gear box. It is black plastic and silver alumnium. Says Kelsey-Hayes right on and has six brake lines attached to it. As for the rear brake take that drum off again and have someone help by pushing the brake pedal down while the drum is off press lightly and very slowly, verify that the brake cylinder is moving, do not push hard and fast as it will probably blow the pistons out of the cylinder! If is is frozen replace it and bleed and it should be fine. The brake light is probably on for low fluid. Let me know how it goes.

May 22, 2009 | 1999 Ford F150 Regular Cab

2 Answers

ABS brakes are locked


Rear wheel bearing has collapsed.... Replace it iced brakes won't put the ABS light on. Dead bearing will!!!!

Jan 22, 2009 | 1995 Land Rover Discovery

3 Answers

Brake light and ABS light is on and the speedometer, odometer and tripometer are inoperable


replace the left front wheel hub assy. with 4 wheel abs. The spedometer works off of the left front wheel sensor. It will fix the abs/brake light and the spedometer will start working

Jul 23, 2008 | 1999 Dodge Durango

Not finding what you are looking for?
1999 Chrysler Cirrus Logo

Related Topics:

151 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61292 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...