Question about 2004 Cadillac Deville

1 Answer

Replacing bulbs How do you replace the light bulbs underneath buttons on steering wheel of a 2004 Cadillac Deville. Buttons control the cruise control etc.

Posted by on

  • blueextc3221
    blueextc3221 May 11, 2010

    these are lit with a fiberoptic light. The source is under the dash. All the buttons are out correct?

  • Anonymous Mar 24, 2014

    how to replace bulb in back up lights 2003 Cadillac deville



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 15,935 Answers

Well... it turns out the 04 is different.
check out this link. it may offer some insight. I understand the bulbd may be replaced in the switches, however you have to remove the aigbag to access....

Posted on Dec 28, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Cruise controlnot working

Do you have an airbag light lit ? Are your cruise control buttons on the steering wheel . If so the clock spring could have an open circuit. A clock spring is a part inside the steering column , under the steering wheel . Check out this video on clock spring . if no airbag light ,then probably not this part.

Nov 23, 2015 | 2004 Chevrolet TrailBlazer

1 Answer

04 Honda Accord EX : The cruise control master switch clicks off immediately after it is pressed; the air bag light comes on and stays on for several days and then goes off all to start the cycle again;...

your problem is a part called a clock spring located underneath the steering to have a shop replace it for you, special wheel puller is required to remove the steering wheel, this part carries wires for all controls and air bag that are control by the steer wheel buttons.

Sep 04, 2011 | 2004 Honda Accord

1 Answer

The light went out on the vol switch on 2003 deville steering wheel

the light bulb is out open the part where the buttons are should be a screw or something holding it in place then change the bulb

Jan 09, 2011 | Cadillac DeVille Cars & Trucks

1 Answer

How to replace cruise control lever 1998 cadillac deville

will need to go to a shop ,
the steering wheel has air bag do not attemp to do it yourself,
if you set the bags off it will cost about 10 gs to replace them,

Apr 14, 2010 | 1998 Cadillac DeVille

1 Answer

Steering wheel buttons dont work on my 2004 accord

Check the fuses and relays. Generally if only 1 accessory doesn't work, the problem is with that particular accessory. When ther are several that don't work, check fuses and relays.

Apr 01, 2010 | 2004 Honda Accord

2 Answers

The light on cruise buttons & part of the heat/air has went out

From Lou on

The bulbs are very inexpensive. They can be purchased at Radio Shack. Two bulbs cost about $2 per set. They are 12 volt, 60 milliamp and they come with long leads. To replace the bulbs in the steering wheel you must first carefully pry out the switch and the unplug it. Then you must carefully unsnap the switch housing. Take extra caution to not break any of the plastic snap fittings and do not lose any parts. The circuit boards contain the mini-lamps and they are soldered onto the board. Snap of the old bulbs , reatin the housing and the blue rubber light covers. Place the new bulb into the old holder, slip on the blue lens cover, snip the leads to about 1/4 inch, and then solder them onto the boards in the old place. Once soldered, carefully bend the bulb over to lay flat. Take the time to replace all of the bulbs. Re-assemble the switch and replace it in the steering wheel.
For the heat control dash lights the entire assembly must be removed. Replace the bulbs inthe same manner as above. The door lights do not need to be soldered, they have a holder that "unscrews" from the circuit board. Just remove the old bulb from the holder, insert the new bulb and twist the leads into place and snip off the excess leads. Then "screw" the holder back into the circuit board.

Oct 04, 2009 | 2002 Buick LeSabre

1 Answer

Illumination of buttons on steering wheel

I have a Sebring Sedan 2005 Limited 2,7 / 6 Cyl. How can I change the illumination bulb of the Instrument Panel ?.
I can't see the Instrument Panel during night.

Mar 23, 2009 | 2004 Chrysler Sebring

2 Answers

Fix lights in steering wheel - 04 DeVille

Steering wheel lights do not have bulbs you can change. The switch is a sealed asembly with an integral light. Each one costs around $110 at the dealership.

Heated seats have wires inside a fabric cover located betwwen the outside seat skin and the inner foam. Over time, they burn out. You can buy replacements from the dealer and have either them or an upholstery shop install them.

Jan 30, 2009 | 2001 Cadillac Seville

1 Answer

Lights out on steering wheel instruments of 200 Taurus

It sounds like you have some bulbs burned out in the cluster and cruise switches. I don't think you can just replace the bulbs in the switch. You can replace bulbs in the instrument cluster.

Jan 29, 2009 | 2000 Ford Taurus

Not finding what you are looking for?
2004 Cadillac Deville Logo

663 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

83644 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22393 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides