Question about 2001 Lexus LS 430

1 Answer

I have a 2001 ls430.... I broke the key that has all the stuff on it to open remotely etc. I have it taped with electrical tape now.. Where can I send this one to get a replacement? Thanks

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

You can by the Key Housing at the dealer.

Posted on Dec 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 Mazda tribute it won't turn over turn the key and nothing happens


have you got power to lights if so are they dim and cut out could be simple batt connection or starter motor,listen carefully when you turn key do you hear anything small "click" by any chance if so lift bonnet look for saddle of wires looks like 8/10 coloured wires all grouped together check the push in connectors maybe corroded open them clean them wd40 them and seal from future water getting into them I put plastic bag over the connector and electric tape round end hope this helps

Mar 13, 2015 | 2001 Mazda Tribute

2 Answers

2001 chevy malibu only starts by remote


probably where the remote start wire was taped into the starter wire got broken and now the key side isn't attached to starter anymore. Id check the starter relay and fuse before anything

Mar 17, 2013 | 2001 Chevrolet Malibu

1 Answer

How do I get the tape out of tape deck the tape wont eject


A SMALL FLAT SCREWDRIVER AND PRESS EJECT AT THE SAME TIME ,MOST LIKELY IT ATE YOUR TAPE ,IF THAT DOESNT WORK TAKE IT OFF THE AND OPEN IT AND THEN REMOVE IT

Feb 14, 2013 | 2001 Dodge Grand Caravan

1 Answer

Land rover lr 3 key padwill not unlock doors battery is charged


There is a splice joint under the passenger side sill plate, under the second plate, about adjacent to the right front seat mounting. Split the harness open. Look for a blue tape with three thin green with white stripe wires. Open the tape. The joint is corroded and broken apart. This feeds the alarm rf receiver. Fix the splice and your remotes will work. - Kyle L.

Jan 07, 2013 | 2005 Land Rover LR3

1 Answer

If wiring harness melts together does that make it bad or can i seperate wires and tape up


It is bad, you want to replace these wires to prevent further issues. Taping with electrical tape will eventually cause more issues. You need these wires insulated in the proper material.

Sep 20, 2012 | 2001 Dodge Caravan

1 Answer

Lost key to my alxus es 400 and need to move car asap


your car should have a spare key taped to the steering column under the dash.....so, look for black electrical tape wound up around the steering post and unwind the tape....you should find a spare key there

Apr 22, 2012 | Cars & Trucks

3 Answers

I have a 2001 nissan maxima 20th anniversary with a bose audio system and my back bose sub and amp dont want to work is it the bose sub or the amp that broke down or is it something else?


hi there,
if the sub has quit working nine times out of ten it is the factory amp that has gone out it could be the speaker but very unlikely hope i have answered you question the best i can have a wonderful day and thank you for using fix ya

Aug 21, 2011 | 2001 Nissan Maxima

1 Answer

What size battery for remote 2001 LS430


Take the reomte to WalMart jewlrey department.. When there - open the reomte & pop the battery out.. They usually have those size batteries & good prices..

Jul 08, 2009 | 2001 Lexus LS 430

1 Answer

Replacing electric seats from a 1995 model into a 1997 facelift.


Technically, you can put any seat in any vehicle, as long as it dosen't interfere with anything. (door closing etc) As far as I know, most jeep seats interchange easily, At worst, you may need to drill a hole or two. Important part is before you begin, identify each wire in the harness, making sure that you know which one does what so if the harnesses don't match you can easily switch wires around. Write it down. Don't try to remember if you do great but if you forget, you can burn stuff out!!! If you need to cut wires, don't twist and tape...twist, solder then tape.
Good luck

Mar 15, 2009 | 1997 Jeep Cherokee Country

5 Answers

2003 Jeep Cherokee Door Panel Electrical Issue


hi
i had the same priblem myself, its an easy fix if your any way handy.
the problem is the main power wire to the drivers door is broke or almost broke (due to switches working when door is closed) between the body off the car and the door you will find a rubber boot,slide the boot back from the car body side and you will find that the thick wire is broke due to the door opening and closing all the time. just add a small piece off cable the same gauge about 2inches (to allow movment in rubber boot) and solder both ends to join. that will solve your problem. ive fixed at least 5 off the jeeps with same problem. try it to see.

mark

Sep 15, 2008 | 2003 Jeep Grand Cherokee

Not finding what you are looking for?
2001 Lexus LS 430 Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...