Question about 1992 Chrysler Lebaron

1 Answer

Head lamps will not work

1992 chrysler lebaron conv 6cyl 3.0 the head lamps will not go on as well as the heater only works coming out of the vents other than the defroster vent. I have already checked the fuses and relays and have checked to make sure that nothing is blocking the vents as well as checking the blower motor. As for the lights I have checked and replaced all fuses and I have replaced both bulbs there is power going to the fuse and to the headlamp switch.

Posted by on

  • innocence_bl Dec 29, 2008

    I have the same problem with this car....the only difference is that my heat only gets hot on the dash vents when i put the heat on the floor person or both it turns from straight hotr heat to cold air and i have no air conditioning but also my radiator has a hole in it pretty big every day i am putting more antifreeze in it. check and see if you dont have a hole in your radiator or your antifreeze lines mine is weird too. im guessing thats my problem but never know. my defrost still works you just have thge opposite problem. keep up with me if you find anything out. ill probably need to know im in WI and it is COLD!!!

  • machadojr_fe Jan 28, 2009

    this ended up being a coolant hose underneath the rear engine mount causing the problem. But thanks for the helps anyway.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

For the defroster only problem, check your vacuum lines. There are even lines under the dash. The switch the controls all that is run on a vacuum. It sounds like you have a head gasket leak. If the leak is big enough, you will lose vacuum pressure. The blower defaults to defrost vents when the vacuum is not strong enough. I had a leak in a vacuum line, causing the blower to switch to defrost, no matter what it was set to.

Posted on Jan 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 92 chrysler lebaron and there is very little heat coming from the heater. The engine is at operational Temp but no heat.


either the heat control valve isn't working, or the heater core is plugged up, what i do is reverse the heater hoses on the core to unplug the core sometimes that is all it takes but if its plugged badly you will need to replace it

Jan 05, 2011 | 1992 Chrysler Lebaron

1 Answer

Mechanic came and fixed my car, rebuilt headand


Yes, the Haynes Manual on your vehicle or the Chilton's manual on your vehicle with have a vacum diagram. Both are available at Amazon.com or your local Auto parts stores. They run about $20.

Jul 26, 2010 | 1989 Chrysler LeBaron

1 Answer

The head lights on come on at all un less u pull on the blinker switch and the heater wont come on at all it stay blowing cold all the time it is a 1992 and need to fix it


two different problems,
one is you need to change the multifunction switch,the turn signal handle/headlight dimmer/
second is your heater,
Since your blower is working and it is a heat issue,thats where we'll start,First thing is have you checked the coolant level in the radiator when engine is cold,make sure it is filled to top,next verify you have coolant in reserve ,Start your van and get it up to normal operation temperature,If your heat gauge on the dash works correctly it should be 190 degrees,Now lift the hood and locate the two heater hoses going into the heater assembly at the fire wall,Both hoses should be hot to hold on to,if both are hot and no heat inside your problem will be the blend air door in heater assembly.
if neither hose is that hot you need to replace the thermostat in the engine to get it up to 195 degrees.
if one hose is hot and one is luke warm then the heater core is blocked and to blame. hope this helps you.

Jan 03, 2010 | 1992 Chrysler Lebaron

1 Answer

I need the belt diagram for the 1992 gtz lebaron conv.


What size engine 3.3, 3.8, 2.2, 2.5? I have all the diagrams if you figure out what engine you have send me a message at my email and a shortcut to this post and I will send you what you need. outdoorsman592003@gmail.com

Sep 16, 2009 | 1992 Chrysler Lebaron

1 Answer

1995 chrysler lebaron


Here's what mine says- for a 95 Chysler LeBaron GTC Convertible. I didn't see anything about a fuel pump, but maybe it's connected to something else? I dunno. Good luck. Here's the info at least.
1 HTR-AC 30A, 2 POWER WINDOWS 30A C/B, 3 PWR SEAT, LKS, TOP 30 A C/B, 4-BLANK, 5 BACK-UP LAMPS 20A, 6 TURN SIGNAL 20A, 7 REAR WIPER 20A, 8 ILLUM LAMPS 5A, 9 INTERIOR LAMPS 10A, 11 CIGAR LIGHTER 20A, 12 RS AMO 20A, 13 INTERIOR LAMPS 10A. 14 BOD COMP MESS CTR 5A, 15 SPEED CONTROL 2A, 16 GAUGES AIRBAGS 5A, 17 STOP LAMPS 18 HEAD LAMP RT-LOW 10A, 19 HEATED MIRRORS 5A, 20 AIRBAGS 5A, 21 STOP LAMOS 20A, 22 HORN 20A, 23 RT-TAIL LAMP-EUR 5A, 24 LT-TAIL LAMP EUR 5A, 25 HEAD LAMP LT-HI 10A, 26 HEAD LAMP RT-HI 10A, 27 RADIO 104, 28 FRONT WIPER 20A

Mar 29, 2009 | 1995 Chrysler LeBaron

1 Answer

1992 chrysler lebaron convertible v6 3.0 Radiator problem


Have this car fuel injection ore carburettor?Are the electrik fan on the radiator? What are the temratur gauge showing whwn the engine overheat? are the car overheating when you drive? If the are el fan , you must check if the fan get 12v when the engine are warm. If you not get 12 v you must check the sensor som start the el fan.
Another things coul be the water pump, ore the termostat. Did you use glykol (anti freze) ore only water on the radiator?

Dec 03, 2008 | 1992 Chrysler Lebaron

1 Answer

Mazda 6cyl head codes and engine codes


The 6 cylinder that comes with it is a 1992 Mazda MX-3 1.8L MFI DOHC 6cyl

Apr 23, 2017 | 1996 Mazda 626

Not finding what you are looking for?
1992 Chrysler Lebaron Logo

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74418 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7254 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...