Question about 1999 Chrysler LHS

1 Answer

Left blinker light stays on solid when headlights are on

At first left blinker would blink and the tail lights and reverse lights stayed on, then the blinker started working when the headlights were off now all fuses are blown and the dash, tail lights etc wont work unless headlights are off and new fuses are in.

Posted by on

  • Anonymous Mar 16, 2014

    front headlight out is there separate fuses for the headlights

  • Anonymous Mar 27, 2014

    Is there a fuse or something.
    the headlight and wipers will
    not work

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 405 Answers

I have had this happen and it is rare, but I have had a filiment burn out in a two filment buld and short to the other filiment. It does happen and I think this might be your problem, the only way to find it is a visual inspection of each bulb. I am sure many people will think this is crazy, but I have had the exact same problem, I had the schematics, tested the circuits,etc. and them by accident found a stop/blinker 1157 bulb that had done this exact thing. I hope this helps you, check the bulbs in your headlights also.

Posted on Dec 27, 2008

  • David Johnson
    David Johnson Dec 27, 2008

    headlights on blows fuses?

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 2007 ford f150 blinkers and 4 ways work fine untill headlights turned on then blinkers stay light but not blinking


Could be the turn singal relay not getting the correct power when lights engaged. Take out bulb from headlight and then turn on headlights. Now no power to the headlights. Try to turn on blinkers now. If they blink replace signal relay, if they still are solid it may be your flasher. Just a guess without looking. Thanks.

Sep 04, 2014 | Ford F-150 Cars & Trucks

1 Answer

Blinkers dont work


You may need to replace the blinker controller, a small device that manages the timing and sequential on/off to the bulbs.

Mar 05, 2014 | 1999 Mazda Millenia

2 Answers

2007 Jeep Grand Cherokee..tail ligts and blinkers do not work when headlights are on..they work otherwise..another problem when headlights or running lights are on and I use left blinker, it blinks...


mporteous, It sounds like you have a light switch problem. I can't think of any other reason for the running lights and tail lights not working in this situation. Are your brake lights working when the headlights are off and how about when they are on? Do your four ways hazard lights work in these situations? Try all the lights under these conditions. The reason the left turn signal blinks very fast is because one of the bulbs are burned out. Try the left signal and one light (front or back) will stay on and the other will not come on at all. Replace the bulb that does nothing. Do this before you try all the lights in different situations. I think that you will have to replace the light switch. Good luck with this.

May 19, 2011 | 2007 Jeep Grand Cherokee Overland

1 Answer

Blinkers dont work properly


start by looking for a bad ground to one of the light sockets

Jul 23, 2010 | 1997 Oldsmobile Cutlass Supreme

2 Answers

When I turn on my headlights, my radio goes dark and plays static. The domelight and floor lights go on, my dashboard lights don't work, and my tail lights don't work. If the headlights are off, the radio...


It sure sounds like you have a case of "sneak circuits"
These are usually caused by a bad ground somewhere and something is "grounding" through the light bulbs.
Have you changed any wiring or installed a stereo or some other accessory?
You might use a jumper wire and ground the dash and other areas to the negative battery post as a way to find the culprit.

Apr 30, 2010 | 1991 Chevrolet S-10 Blazer

1 Answer

2002 trailblazer when i put my blinker on to turn left both bliners blink when light are off, when they are on the left turn signal stays solid


THERE IS A BLINKER RELAY UNDER THE DASH. IF YOU CAN GET ONE OF THE BLINKERS TO BLINK YOU CAN HEAR THE RELAY LISTEN CLOSLEY THEY PUT THESE THINGS IN SOME HARD TO GET PLACES

Oct 12, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

Blinks Fast, and Light Stays On.


check the relay and blown out bulbs will cause the lights to blink fast or some to stay on. one bad bulb will cause the problems.

Jul 14, 2009 | 2002 Chevrolet Cavalier Coupe

1 Answer

Left blinker problems


That's an issue with wiring somewhere alont the line. There has to be a short somewhere. Hopefully for you the short is from the new taillight assembly being installed and it would be relatively easy to get to. Hope it helps!

Jul 03, 2009 | 1991 GMC Sonoma

Not finding what you are looking for?
1999 Chrysler LHS Logo

619 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...