Question about 1999 Isuzu Trooper

1 Answer

On my trooper 1989 the oil meter it is not working

Ckecked the line get12.5 v but the meter will not move
took the wire to grd the meter move too 100

Posted by on

  • luis8750 Dec 27, 2008

    there are two senser on the engine which one



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 78 Answers

Its the senser on the engine need a new one.

Posted on Dec 27, 2008

  • Jerry Cassel Dec 27, 2008

    Pull the wire off the senser and ground it. Turn on the key, the needle will peg if its the right one.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Need dash wiring diagram for 1989 Trooper. Please.

Check with a Haynes or chiltons manual, there will be full wiring diagrams incuded

Nov 11, 2014 | 1989 Isuzu Trooper

1 Answer

Oil going into carb when put in gear 1989 isuzu trooper

sounds like excessive blow by.You can depending where you live reroute blow by line further up the intake tract.Or vent to the air with a filter on the end to catch oil.

Jan 22, 2014 | Isuzu Trooper Cars & Trucks

1 Answer

1994 trooper trans light blinking took it in shop did a trans flush filter,gaskit and tran oil change. but this is the thing trooper misses and tran hold back but when shop checks computer reads nothing...

check out the neutral saftey switch on trans, if its reporting unknown gear on scanner while moving t bar it wont know what gear to be in and give you similar problems, also has oil been leaking into switch before?

Feb 17, 2011 | 1994 Isuzu Trooper

1 Answer

I push my clutch down and it stays there the car wont go into gear unless it is off it like i'm not pushing the clutch at all. I checked the fluid in the clutch hydraulic reservoir and its full. Is the...

Try this select gear before starting the engine then start the engine if this helps then its a clutch fault.also try bleed out the hydraulic clutch.The slave cylinder on the gear box gave trouble on thease models ckeck that there is no oil leaking out of the cylinder..

Dec 05, 2010 | 1989 Isuzu Trooper

1 Answer

I need to know what sort of oil my peugeot 405 GRD (1989) uses please. I'm a bit cartech useless 8-/

being diesel and its age i would recommend using a 10/40 or if its burning oil,say a pint every 1000 miles then use 20/50 most of the multigrades will be petrol and diesel.

Sep 03, 2010 | 1989 Peugeot 405

1 Answer

1989 trooper just died

Have a 2.6 with the same issues. only mine will almost always start after disconnecting the fuel line and reconnecting it. I have replaced the fuel pump, inline filter and pressure regulator. My car dog friends are telling me it's the injectors.

Sep 03, 2008 | 1989 Isuzu Trooper

Not finding what you are looking for?
1999 Isuzu Trooper Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14423 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides