1991 Nissan Stanza Logo

Related Topics:

jesse samuell Posted on Sep 17, 2012
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

WHERES THE MODULE - 1991 Nissan Stanza

1 Answer

Phil Lovisek

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Nissan Master 726 Answers
  • Posted on Sep 18, 2012
Phil Lovisek
Nissan Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: Jul 17, 2008
Answers
726
Questions
6
Helped
421295
Points
1727

Under the radio on the floor by your feet. there is a cover to the right of the gas pedal. take off that cover and you should see the computer. it is botlet to the floor of the car.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Wheres is my body control module on a 97 chevy camaro v6

Body Control Module (BCM)
Under the right side of the instrument panel near the blower motor
0helpful
2answers

Wheres the ingnition control module on a 2001 ford f150

With cop ignition, two wire ignition coil, ic control is in the pcm.
Voltage to the coil goes hot when you turn on the key, fuse protected. Your computer controls the coil ground circuit. I'm not sure about engine size?
ignition coil-dkww15fqtro1ypfgge5zegwe-4-0.jpg
0helpful
1answer

Wheres the ignition module located

The ignition module is inside the distributor.
0helpful
1answer

Wheres is the crank sensor for a 1987 ford ranger 2.3l 4x4 4cylinder

This truck uses a distributor, so the job of crank - cam sensors is handled by the pick-up coil in the dist.
Is the coil and module getting power from the EEC relay ?
0helpful
1answer

99 denali wheres is the anti theft module located

Most are under the glove box. Tucked up under the dash board. Trucks might different. If you are trying to bypass it, check out this link http://vatspasslockpasskeysecurityhelp.yolasite.com/
0helpful
1answer

Wheres the module located

if its the ignition module should be on outside of distributor or inside below the rotor and advance plate. some cars have a seperat unit normally located on inner guard under bonnet
0helpful
1answer

Wheres the air ride compressor relay located

The 2003 Navigator COMPRESSOR module is located under the dash on drivers side above the parking brake pedal.

Read more: http://wiki.answers.com/Q/Where_is_the_air_ride_suspension_relay_on_a_2003_lincoln_navigator_located#ixzz1AWFpFFoj
0helpful
1answer

Wheres the fuel pump

the electric fuel pump is located inside the gas tank, the tank must be removed from the car to replace the pump module
9helpful
2answers

Wheres the circuit board for a windshield wiper

Hello jlwhelchel: My name is Roger and I will answer your question. Raise the hood locate the wiper motor. Remove the cover held on by three screws. Remove the cover. The cover is the module.
Should you need further help please just ask. Please rate the answer. This way I know the information was helpful. Thank You for using Fix Ya. Roger
Not finding what you are looking for?

50 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...