Question about 1998 Ford Contour

3 Answers

Car wont shift out of park and blower motor quit.

Turn signal burned out, replaced it and blower quit working. got parked and it wouldnt shift out of park.

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Fuse #23 controls the turn signals, heater blower, reverse lamps, and the shift lever solenoid. There is a hole in the right side of the console where you can poke around with a ball point pen and unlock the shift lever. The fuse is located in a panel behind the glove box. I took my car to a dealer and had them change the fuse, but the ball point pen trick will save you a tow job.

Posted on May 14, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Belive it it's a fuse under the dash , it happened to me

Posted on Apr 01, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 21,990 Answers

Blown fuse

Posted on Jan 23, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wont shift into park


Column shift? Check all linkage for binding and excess play. Grease linkage. When did you last change trans filter and fluid?

Jan 31, 2014 | Chevrolet Tahoe Cars & Trucks

1 Answer

My 2006 Buick Lucern wont come out of park the car starts up without a problem i was driving one minute get back and the car and the shift wouldnt come out of park


When parked on an incline, engage emergency brake FIRST, then shift into Park. Hope this helps! Works for my Buick.

Jan 11, 2013 | 2006 Buick Lucerne

1 Answer

97 mazda 626 wont shift from park. release button on side of shifter wont push in. removed knob, plastic rod in center wont move


The 1st thing you need to do is check the brake lights, if they are not wiorking the park lock solenoid doesn't get power and the park lock remains engaged.

Apr 17, 2012 | 1997 Mazda 626

1 Answer

1995 ford ranger wont come out of park


try disconnecting the rods from the ignition switch shift lever inhibitor.this is basically the mechanism which prevents you from turning the ignition switch to the 'lock' position when the shift lever is not in the 'park' position

Jan 27, 2012 | 1995 Ford Ranger Supercab

1 Answer

1996 Park Ave, blower motor is intermittent... when it does work, the speed changes when I take a turn. It has Climate Control, so I think the control module is the culprit, but I can't find the darn...


Automatic climate control? The HVAC control module is the part with the buttons that control the heater in the dash.

The first thing I would do is access the blower motor. With key on and/or the engine running wiggle the connector at the blower motor. It you get the same symptom than replace the blower motor. I run into quite a few of these with this symptom.

Oct 07, 2011 | 1996 Buick Park Avenue

1 Answer

Car wont start something to do wiv park on gear shift


your linkage may need adjusting. I had a problem like this when I put it in park, my reverse lights were on and it wouldnt re-start until i shoved the gear shift hard into park. Check this out first.

Mar 24, 2011 | Jaguar XJ6 Cars & Trucks

1 Answer

The turning signals and heater blower dont work on my 99 mystique


when checking fuses pull one and check the wire lead or flat metal lead going from side to side of the fuse if you dont see a burn or dark spot its ok replace it and continue this until you have found the bad ones of check your bulbs sometime a bad bulb will not let the others work properly.If these do not work chect your signal switch also known as a multifunction switch.I would not attempt to chang the blower if its not a fuse because they can be hazerdly.

Mar 30, 2009 | 1999 Mercury Mystique

1 Answer

Blower motor on Park AVe '94


Relace blower control module.

Jan 18, 2009 | 1994 Buick Park Avenue

2 Answers

My speedometer and cruise control both quit working


try replacing vehicle speed sensors. you need a good vehicle speed signal inorder for cruise and tha speedometer to operate properly

Oct 24, 2008 | 1991 Ford Probe

Not finding what you are looking for?
1998 Ford Contour Logo

337 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...