Pink coolant leaks on top of engine 2006 dodge charger se

SOURCE: 2004 dodge stratus leaking coolant

there is a temporary fix for this until you can get it replaced, you will need 4 washers wide enough to fit around the lip of the upper half. Remove the 4 bolts holding the outlet and place the washers on the bolts and tighten down lightly enough to prevent leakage, this will fix it on a temp bases only until it can properly be repaired.

SOURCE: 98 Expedition coolant leak top back of engin

Sorry im late with this,i couldnt seem to log on....The answer to your question is YES,there is a steel line under the intake with a short piece of rubber line attached to it and you can just about see it from the front of the intake with a light,it can leak and cause coolant to run off the back of the engine,The intake gasket set alone is about $40.00 and i dont know about the rubber line,i have seen it physically but havent changed one yet.Note the date of manufactor just incase,i bought an intake set for a 99 and the engine design was changed half way through...its not too hard to pull off the intake and re-install,you will need a 7mm socket for the coil packs,8mm socket for the fuel rail bolts and lower intake bolts and power steering bracket bolts and throttle bracket bolts,10mm socket for the intake bolts and alternator bolts and egr valve,and a large cresant wrench for the exhaust tube thats connected to the egr valve,flat screw driver for the air cleaner...and plenty of extensions with a swivel to be able to get to the back bolts of the intake....just incase you do it yourself this info could make it easier to gather tools.Its about a 3 1\2 to 4 hour job start to finish for the first time doing it,includes cleaning everything..Good luck

SOURCE: 2006 Pontiac Torrent heater blowing cold air

hi
check the heater hoses and if both are hot then the mode door is broken
i have replaced 2 in the torrents(not a nice job)

SOURCE: COOLANT LEAK - MID -ENGINE 2.4L 99 GRAND AM SE

check the upper rad hose to engine there is a plastic housing with a seal replace it

SOURCE: Water Pump leakes from steel tube.

when installing new o-ring on tube, lubricate o-ring and stick it in water pump. Then pull pressure back on tube and then tighten hold down clamp. problem solved