SOURCE: 1999 Chevy Blazer Starter
the starter is located on the passenger side lower motor. it has two bolts in it that hold it in place. it actually goes through a hole/slot in the transmission to the flex plate.
1st. disconnect the negative cable on the battery.
2nd. raise the vehicle safely and place a jack stand under the vehicle out of your way but near where you will be working(for safety).
3rd. remove the two bolts that hold the starter in place.
4th. remove the wires from the back of the starter.
5th. install in reverse order of above.
note: there may be little plates between the starter and the mounting points called shims. if there are then make sure you put them back.
SOURCE: 97 chevy blazer
There are no free full diagrams on the net, you need to charge and test the battery, clean the battery cables and run a voltage drop test as well, replace them if the are badly corroded. Kragen will test the battery for free.
SOURCE: Chevy S10 Pickup Starter. Removed the two bolts
Just changed a starter in a 94 S10 4x4. The only way to remove the starter was to take the passenger side exhaust manifold off and bring the starter out that way. Installation the same in reverse. Hope this helps. Don
SOURCE: 1997 chevy blazer heater does not blow already
check the blower motor resistor, it on passenger side under dash bolted to heater box, those go bad often, hope this is helpful.
632 views
Usually answered in minutes!
×