Question about 2000 Chevrolet Corvette

1 Answer

Locatiion of oil filter on 2000 corvette

Need to change oil-can't locate filter

Posted by on

  • brando11151 Jan 03, 2009

    I can't find the oil filter of my Landcruiser 2002? I'm trying to change the engine oil. Please help me?

    broderick

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Jack the car up. The filter is under it next to the oil plug. Careful not to bend the car. It has certain spots it can be lifted.

Posted on May 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change fuel filter in 2000 corvette


Hello, my name is Ben. This can be a bit tricky, but it is do-able. You will need to buy the fuel line quick disconnect tool from a parts store. The filter is on the driver's side above the muffler beside the transmission. First unbolt the filter and then dis connect the fuel lines, install the new filter reversing the steps.

Jun 22, 2010 | 2000 Chevrolet Corvette

1 Answer

My oil light keeps coming on in my car, but when I check the oil it's full.


Could be a faulty oil sending unit, which is usually located by the oil filter, a weak oil pump, or just needs a good old oil and filter change.

Apr 28, 2010 | 2000 Dodge Intrepid

1 Answer

2000 ford epedition location of oil pressure


Right beside the oil filter. easy to change and cheap part. $30 for part and 10 min to change. just be sure you have old paper or something to cover your area from oil leaking.

Jan 15, 2010 | 2000 Ford Expedition

1 Answer

Where is the oil filter located on a 2000 intrigue


It is an internal filter. It is located in the oil pan. It has a cap on the oil pan that almost looks like you can take it off with your hand. Chances are however you cant. You can change it yourself with the correct size oil filter wrench. I wish I could tell you what size it was but I use a strap wrench to take it off. Most places sell the filter. Fram # is Ch8765.

Oct 08, 2009 | 2000 Oldsmobile Intrigue

2 Answers

Where is the oil filter located?


driver side on front of the radiator

Jul 02, 2009 | 2000 Mercedes-Benz E-Class

2 Answers

Need to change the transmission fluid in my 98 corvette


to change your tranny fluid and filter is relativily easy i will tell you step by step here.
1. raise the vehicle and support it with jack stands
2. get a large drain pan
3. locate the transmission oil pand and losen all the bolts removing the rear half of the bolts only and just losening the other bolts to keep the pan held up but allowing it to sag on the rear.
4 be carefull because in this step your likely to get a bath in tranny fluid. insert a flat srewdriver in the back of the pan and carefully pry it lose. now trany fluid is going to pour out of the pan.
5. remove the rest of the bolts be carefull because the trany pan still has a lot of fluid in it.
6. grab ahold of the filter and pull it down.
7. insert the new filter but make sure the rubber gasket came offf with the old filter they have a tendency to stick in the transmission.
8 replace oil pan and torque down evenly
9 refill with correct fluid to the correct level
10 take for a drive and recheck the fluid level and check for transmission fluid leaks
ps when the pan is off clean the inside of it out with brake cleaner really good
If there are no leaks after you get done congratulate your self on a job well done

hope this helps you
please rate me
Thank you

Apr 21, 2009 | 1998 Chevrolet Corvette

2 Answers

1985 Corvette Shuts off after heats up..


did u change fuel pump relay? its located on the firewall on drivers side over the years they go bad from heat in engine compartment and car will shut off when at a stop or when on highway its a 15 dollar part and it wouldnt hurt to change

Mar 10, 2009 | 1985 Chevrolet Corvette

2 Answers

Pontiac Bonneville(2000) oil pressure sending unit


The oil pressure sending unit is located behind the oil filter, Threaded into an aluminunm housing. It has wiring that plugs into the sending unit. The oil filter has to be removed and you will need a deep well socket and a 6 inch extension. Change the oil and the sending unit together.

Jan 24, 2009 | 2000 Pontiac Bonneville

1 Answer

1960 corvette oil filter


You may have double ringed the filter, this is when the old O ring stays on the filter base and you don't notice it, will leak like a sieve, pull the filter back off and check this.

Oct 16, 2008 | 1965 Chevrolet Corvette

Not finding what you are looking for?
2000 Chevrolet Corvette Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...