You have to take off the speedometer cable/wiring harness from the top of the trans and fill it from there....one 10mm bolt...very awkward spot...it might be snug, so just take a flat head screwdriver from underneath to tap it loose...
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Use a bottle with a long narrow spout. Fill until oil just starts to come back out of the fill hole. let oil stop dripping from filler hole before you put back the filler plug or it will be over filled.
you have to take off the speedometer cable/wiring harness from the top of the trans and fill it from there....one 10mm bolt...very awkward spot...it might be snug, so just take a flat head screwdriver from underneath to tap it loose...
first, you have to drain the oil from the drain plug located at the bottom of the oil pan,
after all of the oil have been drain, tighten back the drain plug bolt.
then remove the old oil filter by using a filter wrench, you would need this wrench because it is very hard to remove by plain hands. the oil filter is located at the bottom of the engine or sometimes at its side.
after removing the old one, apply a thin coat of new oil to the rubber o-rings of the new oil filter before inserting just to make a good seal as you tighten it.
now open the oil filler cap at the top of the engine and pour the exact amount of new oil that was specified in your book. and also the correct type of oil that it uses.
then start the engine for 5 mins, turn t off and check the amount of oil at the dip stick. add if necessary..