Question about 2000 Toyota Camry

1 Answer

A swishing sound when starting (some times) then starts.

When starting I here a swishing sound but on second attempt it always starts.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 90 Answers

So it doesnt start on first attempt? How often does this happen. Swishing is usually associated with an air pocket in the cooling system, but shouldnt prevent it from starting in any conceivable way. Possibly the starter isnt engauging the flywheel?

Posted on Jan 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Swishing sound when engine starts


replace the steering hose cable. Then take the gallon of water out the back seat.

Feb 02, 2014 | 2004 Honda Accord

3 Answers

Starting problem


You need to change either the ignition block or the starter motor.

May 28, 2008 | 2006 Suzuki Grand Vitara

1 Answer

Caprice New Starter


fuel filter that what i would change

Jul 28, 2012 | 1994 Chevrolet Caprice

1 Answer

Vehicle starts runs for 2 seconds then shuts off 2006 santa fe 4 cyl standard, not the battery started multiple times and shuts off after 2 seconds every time what is it?


Possibly a weak or dead fuel pump. Try disconnecting the fuel line where it enters the fuel rail ( the metal tube that the injectors are attached to.) Have someone turn the key to the "RUN" position, (not "START") a few times and observe the fuel flow. If it appears weak, then you probably have a bad pump. Be sure to capture the fuel that spills out and DO NOT attempt this while the engine is hot. Altenatetively, you can have someone turn the key "ON" and off a few times while you listen for the humming sound of the pump at the fuel tank. But just because you can hear a humming sound doesn't always mean the pump is operating to capacity. If this doesn't help, reply bvack and we can go from there. Good luck!

Jun 02, 2011 | 2004 Hyundai Santa Fe

2 Answers

When i turn my car on. it stays on for a second then turns off and it does that for several attempts till i pump the gas while i turn the switch?


check fuel psi sounds like a pump going bad but always change the filter frist because it my be pluged.goodluck

Jan 26, 2011 | 1983 Chevrolet Impala

1 Answer

Change battery everything gone dead will not take land rover disc


Firstly, pop a new battery in the fob.
Now we can enter the EKA.
Close all the doors.
Turn the key in the driver door lock to the unlock position and hold there for at least 5 seconds until the alarm sounds once. Then return to centre - always ensure you return to centre and do not delay more than 10 seconds between turns, or hold in the position for more than 5 seconds or you will reset to the start. Turn to full extent of travel.
1st Digit turn to unlock the number of times specified.
2nd Digit turn to lock the number of times specified.
3rd Digit turn to unlock the number of times specified.
4th Digit turn to lock the number of times specified.
Finally turn to unlock once more. If it is correct a double bleep will sound (single bleep is incorrect code)
You now have a 5 minute delay - don't open any doors. The anti-theft indicator will continue flashing once every 2 seconds for the five minute period. When this goes out, open the door and start within 30secs.
After 3 failed attempts, the security system invokes a delay period of 10 mins during which the system will not accept any further attempts to enter a code.

Jan 18, 2010 | 2004 Land Rover Discovery

1 Answer

I have the code for my 2002 land rover discovery i just dont know how to put it in, any ideas thanks


To enter the EKA:
Close all the doors.
Turn the key in the driver door lock to the unlock position and hold there for at least 5 seconds until the alarm sounds once. Then return to centre - always ensure you return to centre and do not delay more than 10 seconds between turns, or hold in the position for more than 5 seconds or you will reset to the start. Turn to full extent of travel.
1st Digit turn to unlock the number of times specified.
2nd Digit turn to lock the number of times specified.
3rd Digit turn to unlock the number of times specified.
4th Digit turn to lock the number of times specified.
Finally turn to unlock once more. If it is correct a double bleep will sound (single bleep is incorrect code)
You now have a 5 minute delay - don't open any doors. The anti-theft indicator will continue flashing once every 2 seconds for the five minute period. When this goes out, open the door and start within 30secs.
After 3 failed attempts, the security system invokes a delay period of 10 mins during which the system will not accept any further attempts to enter a code.

Oct 19, 2009 | 2002 Land Rover Discovery Series II

1 Answer

Ekc on land rover disco 2 v8


Well, you may not need to take it to a dealer if you have the EKA code.
Firstly, pop a new battery in the fob. Get the vehicles battery charged up or changed.
Now we can enter the EKA.
Close all the doors.
Turn the key in the driver door lock to the unlock position and hold there for at least 5 seconds until the alarm sounds once. Then return to centre - always ensure you return to centre and do not delay more than 10 seconds between turns, or hold in the position for more than 5 seconds or you will reset to the start. Turn to full extent of travel.
1st Digit turn to unlock the number of times specified.
2nd Digit turn to lock the number of times specified.
3rd Digit turn to unlock the number of times specified.
4th Digit turn to lock the number of times specified.
Finally turn to unlock once more. If it is correct a double bleep will sound (single bleep is incorrect code)
You now have a 5 minute delay - don't open any doors. The anti-theft indicator will continue flashing once every 2 seconds for the five minute period. When this goes out, open the door and start within 30secs.
After 3 failed attempts, the security system invokes a delay period of 10 mins during which the system will not accept any further attempts to enter a code.

Mar 02, 2009 | 2003 Land Rover Discovery

2 Answers

Hard but eventual start


Sounds like you may have a leaky injector which is both leaking fuel into one of the cylinders, and bleeding down any fuel rail pressure. Extra fuel makes it hard to start, loss of rail pressure takes a few seconds for fuel pump to build pressure back up.

Jan 24, 2009 | 2001 Dodge Dakota

Not finding what you are looking for?
2000 Toyota Camry Logo

Related Topics:

176 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...