Question about 1994 Chevrolet Camaro

1 Answer

I have no heat in my 94 z28. i have changed out the thermostat and the lines running to the heater coil are hot. i took the lid off the radiator and the coolant is flowing. where is the motor moves the diverter from hot to cold located?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 2,920 Answers

Have you checked the heater core? if its clogged you wont get any heat

Posted on Dec 25, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Okay i have a '89 ford f150 4x4 standard single cab short wheel base with a 302 & i just replaced the thermostat 180 degrees & replaced the fan clutch because thermostat stuck & fan clutch was bad & it ran...

Its possible that you got a faulty thermostat that is actually sticking open and not allowing the water to actually heat up to temperature. Try checking the heater and see if you actually have heat. If not, I would start there and purchase another thermostat. It's the cheapest route and I have purchased bad ones myself.

Aug 14, 2014 | Cars & Trucks

2 Answers

Engine overheat and no heat

Maybe your radiator is clogged.

Mar 12, 2017 | 2001 Nissan Sentra

2 Answers

Drained radiator added prestone Radiator flush refilled and started overheating, drained radiator replaced thermostat and now I get no heat from heater,Radiator water is hot

disconnect the heat hoses going into fire wall , put hose into one with pressure and flush as it sounds like it could be bloked in the heater core,the other thing that could be the problem be the hot ,cold switch as it restricts the flow to makes the heater hoter or colder , it might need tlc or replacing as it is manaul not elec

May 08, 2012 | 1995 Toyota 4Runner

3 Answers

1998 chevy blazer After the repair shop replaced the blown intake gasket, I have no heat from the heater. I took the heater hoses off and ran water thru the heater but still no heat

Is the vehicle running at normal temperature..If its running cooler than normal,then it might be the thermostat..Feel the upper radiator hose after the vehicle hot..It should be hot to touch

Sep 05, 2011 | 1998 Chevrolet Blazer

2 Answers

2002 Hyundai Elantra, thermostat, radiator, and fluid has been

the solenoid that opens the hot water into the coil is not opening

Dec 31, 2009 | 2001 Hyundai Elantra

1 Answer

No heat, lincoln town car, new heat control valve, new radiator, new water pump, new heater coil

It looks like you changed everything involving the hot water. When the engine is warm, you should be getting hot water going through the heater core. By holding each hose from the heater core you should feel heat from both hoses. I did not see a new thermostat listed.

You need to also have the ductwork under the dash moving correctly. If you find that the water lines from the heater core are both hot, then you need the (doors) or flaps in the ductwork to route the heat inside. I do not see that anything was looked at under the dash.

Dec 15, 2009 | 1996 Lincoln Town Car

3 Answers

1996 328IS, Over heating after 25 minutes of idling,

clogged with old rad chunks
no white smoke

Sep 05, 2009 | 1997 BMW 328

1 Answer

1986 VW Golf GTI 1.8 SOHC cooling issues, and heater blows cool

try changing cooland temp sender,your heater matrix maybe blocked(common)what temp is it running at have you checked it with a gauge?

Dec 22, 2008 | 1986 Volkswagen Golf

Not finding what you are looking for?
1994 Chevrolet Camaro Logo

411 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides