Question about 1988 Honda Accord 4 Door

1 Answer

1988 HONDA ACCORD BLOWER WONT WORK

I replaced the blower moter and checker all my fuses can anyone help me? Also the lights abover fresh and Rec air dont come on but they come on over all the other on the heat a/c control.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I just had the same problem on my 88 honda accord lx had to replace ignition switch

Posted on Dec 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ac/heater fan doesn't work


According to my wiring diagram, the blue and white wire from the blower motor gets power from the key switch. The fan switch and resistor grounds the motor.
No blower fuse is listed.

Feb 03, 2013 | 1988 Honda Accord 4 Door

1 Answer

1988 Honda Accord will not start,, lights work but doesn't try to turn over


check the battery voltage ,. if it;s above 12 volts then test the wire going to the solenoid to see if it has 12 volts when turning the key to start. if it does then the solenoid or starter could be bad/

Jul 22, 2012 | 1988 Honda Accord 4 Door

1 Answer

1992 accord heating the blower for heating and


you need to look under the hood for a relay center an you will find one ther for the blower moter I woul google your year car and it should show you hte position for the fuses and the relay

Aug 01, 2010 | 1992 Honda Accord

2 Answers

My heater and AC blower not working. Please help


In the fuse block,under the hood on top of the fender. Locate fuse #35 it's 40amp fuse for the blower moter. If the fuse is ok,there is another
common problem you can check. The blower moter resistor assembly,
located under the dash on right side. With a 12v test light check for
power to the blower moter from the resistor. If you have no power to the
moter, replace the resistor assembly. If niether of these works, I'll need
to know if you have climate control or manual control hvac. And for some reason, the wheel base. long wb or short wb. to dig any deeper.
But I hope one of the causes I've mentioned will cure the problem.
Good luck.

Feb 26, 2010 | 2005 GMC Envoy

1 Answer

Blower moter went out


check fuses,relays and the blower switch if these are ok then change blower.

Oct 25, 2009 | 1991 Honda Accord

1 Answer

Heater blower doesnt work on 1993 honda accord


its usually under the dash in the passanger side or on the passanger side on the fire wall

Oct 22, 2009 | 1993 Honda Accord

1 Answer

94 accord: drive light blinks and check engine light is on...will only start if the battery terminal is taken off and then put back on...


hi..

mostly they have a thermal fuse in them that blows if too much of heat builds up in them and they have an improved blower moter thermal fuze kit for them i suspect thats the promblem....if thats the problem try to replace the thermal fuse

thank u
rate me

Jul 24, 2009 | 1994 Honda Accord

1 Answer

I have a 1988 GMC 3500 and the dash lights do not work. In addition when I turn on the running lights the digital lighting for the a/c - heat display go out. I hav checked all the fuses and they are fine.


mostly they have a thermal fuse in them that blows if too much of heat builds up in them and they have an improved blower moter thermal fuze kit for them i suspect thats the promblem....if thats the problem try to replace the thermal fuse

Jun 28, 2009 | 1988 GMC C3500

1 Answer

How do i pull out a faulty heater blower motor from behind glovebox in 91 accord?


For Pictured Detailed Innstruction see Bottom of Page


BLOWER UNIT REMOVAL
  1. Remove the glove box.
2. Remove Glove box FRAME
3. Pull back the carpet and remove the kick panel. Remove the control unit bracket mounting nuts (4). Disconnect the connectors (5) and remove the control unit and bracket.

  1. Without A/C:
    • Remove the self-tapping screws (3) and remove the heater duct.
    • Remove the blower (3 nuts).
  • If the car has A/C, remove the blower unit according to the sequence shown
  • BLOWER MOTOR REPLACEMENT
    Refer to illustration for blower unit disassembly and reassembly, noting the following:
    • Before reassembly, make sure that the air door and linkage moves smoothly without binding.
    • When reattaching the recirculation control motor, make sure its positioning will not allow the air door to be pulled too far. Attach the recirculation control motor and all linkage, then apply battery voltage and watch the recirculation control door movement. If necessary, loosen the holding screw and move the recirculation control motor up or down
    • CONTROL ROD ADJUSTMENT
      Connect the recirculation control motor connector to the main wire harness and turn the FRE/REC switch to "REC". Hold the air door closed, then connect the control rod to the clip on the arm.
    • Email Me at the nickkname shown here >>rejakwilson @aol.com

Jan 18, 2009 | 1991 Honda Accord

1 Answer

1988 honda accord lx-i gear shift panel lights


hello first you need to check the bulb below the gear shift panel that is not blown then if available your book on your car has a listing page usually in back look for fuses go to page it should have a diagram for fuses see wich one is for illumination of your shifter check fuse replace if needed goodluck

Aug 09, 2008 | 1988 Honda Accord 4 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

370 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...