Question about 1998 Chevrolet S-10 Pickup

1 Answer

No gas to spark plug, but I have fuel pressure

Check fuel pressure, ok

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 166 Answers

Sounds like you have no injection from the injectors check for a pulse at the injectors you can do this by getting a noid light from your local tool shop and plug it in and crankthe engine over if no pulse you may have a computer problem our a dissy module problem have you got spark at the plugs?
if so the dissy is ok and your computer may be faulty there are companies that can test your computer farly cheaply and if it is no good provide you with a replacment

Posted on Dec 25, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

4 Answers

93 Buick PA ran out of gas, batt died. Change battery and put gas,new fuel filter,New coils and base spark wires,cam and crank censor,fuel pump /sending unit still no start

Check for a good spark at the plugs ,if ok check fuel pressure and fuel flow. fuel pressure should be around 300 kpa, Flow around 500 ml, in 30 seconds.

Feb 23, 2015 | 1993 Buick Park Avenue

1 Answer

Well ,it is a 2000 chevy blazer 2 door, i put a new fuel pump,and fuel filter,and it still will not start,if you put gas in the carburradtor it will start for a second then it dies,what could be the

Did you verify that you have proper fuel pressure? Should be around 60 PSI. If pressure is low, ensure that fuel filter is not installed backwards. If fuel pressure is OK, check your injectors with a noid light to see if you have injector pulse. If the truck starts with gas poured into the intake, it is NOT the spark plugs causing the problem. You are chasing a fuel delivery issue, NOT a spark issue.

Feb 24, 2013 | 2000 Chevrolet Blazer

1 Answer

Got fuel and spark but it wont start

If it is the 4 cyl engine, have you checked to see if the timing belt is ok and the engine has compression ?
If it has compression, and the plugs are wet, they could be fuel fouled.
I would try a new set of plugs, check the fuel pressure to make sure it is within spec, and check all plugs for spark.

Dec 08, 2012 | 1998 Ford Ranger

1 Answer

When i try to start my 99 vw passat gls v6 it will barely start and stay started for possibly 5 sec with no presure on gas pedal if i keep my foot on the gas it will stay running but the rpms wont rise...

it hard to say there few things that could cause this but sounds like it a Fuel issue
Possible bad fuel pump totallly clogged fuel filter bad injectors Out of gas etc.
first thing you need to do is check your fuel pressure ( I bet it be low ) if it low check fuel filter if fuel filter good replace fuel pump
If Fuel pressure is within Specs then test the injectors
if Fuel pressure is ok and injectors test out ok then check ignition system (spark plugs, coils, module etc)

May 11, 2011 | 1999 Volkswagen Passat

1 Answer

1996 chevy blazer truck won't start suspect fuel not getting to spark plugs... replace fuel filter checked relay in the glove box Ok opened steel fuel line at intake and it was pressurized vehicle still...

take nomber one sparke plug out and tape a paper there turn the motor over 3-4 times if the paper is wet then you are getting gas if not it could be an injector try some fuel cleaner in you gas

Feb 23, 2011 | 1996 Chevrolet Blazer

2 Answers

I have a 1998 gmc jimmy I have spark i have 61-66 psi of fuel pressure but it will not start

OK, you have spark at the spark plugs, right? You have more than adequate fuel pressure. Do you have fuel in the cylinders? Pull a spark plug to see if they are wet with gas. If you have spark at the plug and fuel in the cylinder, it should start. Is this a recent problem, or has the truck been sitting for a while.?

Dec 31, 2010 | GMC Jimmy Cars & Trucks

1 Answer

Crank over but wont start

First thing I would do is check the basics, verify you have adequate fuel pressure by hooking up a fuel pressure gauge to your fuel rail assembly, next after you have verified thats ok check if you have spark going to your spark plugs, remove one of the spark plugs and hook a spark tester up to the spark plug wire, observe as your cranking the engine around if you see a spark on the tester or not, next if that passes you may have a cylinder compression problem, remove all spark plugs and perform a cylinder compression test, if all the cylinders seem to have low or no compression you have a valve timing issue, check and see if your timing belt is in proper time with the timing marks or if the belt is connected and has not broken, if you have a no spark condition check and verify your ignition module is getting 12 volt battery power with a test light, if you have 12 volts there next look into the crankshaft position sensor make sure the ohm resisitance is within the proper spec for your vehical if thats not correct replace the sensor with a new unit, finally if you find you have no fuel pressure check the fuel pump relay and fuse and verify there both ok if you find these to be both good, you more then likely have a bad fuel pump and that will require removal of the gas tank for further inspection of the pump assembly....

Dec 10, 2010 | 1998 Chrysler Sebring

1 Answer

Bmw will not start

if the car is cranking you should ensure that there is fuel supply,check at the shrader valve on the top of the fuel rail.if there is substantial amount of gas it is probably ok but you should really hook up a gas guage to ensure proper pressure,if there is no pressure check fuse 54 for fuel pump,if is ok remove rear seat and access fuel pump at r side of tank,remove connection and measure for 12v on the brown ( ground) wire and the red wire (power) these two wires are the largest,12v should be present when cranking the engine if there is no voltage present you may have a bad pump or a faulty fuel pump relay,if you have gas spark should be checked,remove a coil and a spark plug,examine the condition of the plug, if it is wet then your engine could also be flooding, plug in the coil and attach the plug to it, have somone crank the engine while you observe for spark(do not hold the plug at this point as it is dangerous) You must have both gas and spark to start a engine,If your engine is not cranking and is making a clicking sound you may have a bad starter,if there is no sound at all try a different key as the EWS or the immobilizer may have lost the code and doesnt recognize the key, Please attempt and let me know what happens, thanks

Feb 21, 2010 | 2001 BMW 325

1 Answer

Alt seems ok but strong fuel smell and new plugs black

use a scanner sound like a bad sensor .mass air flow - map sensor - coolant sensor. check vacuum line to fuel pressure regulator if wet with gas replace fuel pressure regulator. make sure yours spark pluge the right heat range. also change air filter. check charcoal canister. check oxygen sensor and egr valve. make sure its not stuck open.

Mar 25, 2009 | 1994 Saturn Sl

1 Answer

1995 blazer was running rough, now not starting

if you believe some one put water or bad gas in your tank, then you will have to drain the tank. however, to know if you have water in your gas, first disconnect fuel return line or the line that goes in to the fuel pressure regulator put some fuel in a clear glass and let it sit for 15min.if you see white cloud at the bottom of the glass or water. drain the tank. if not check for spark by removing one spark plug wire and spark plug. place the spark plug in the spark plug wire boot and touch it on the metal part of the car. do not touch the spark plug itself only the booth with the plug in the boot. have some one crank the car over. if you see spark, the spark part is ok. but if no spark, check the coil with a volt meter it should be 3 to 8 ohm if not replace the coil. if ok, check for fuel by removing one spark plug or two and see if they are wet,if wet pump is ok. if not check the fuel pump relay and fuse. if fuse is blown replace. check relay with a volt meter. resistance of the relay should be between 40 to 80 ohm. not mega ohm,if mega ohm, replace. if not , listen to the fuel pump while some one is cranking the car. if you donot hear the pump, disconnect the pump electrical connector and applive 12 volt and ground to the pump by using a jumper or any wire and listen for pump sound. if not replace the pump. if there is sound coming from the pump, it is ok. check the fuel pressure regulator with a fuel pressure gauge or simply disconnect the vaccum from the regulator and try starting the car. if fuel pump is ok and spark is ok. then it maybe the computer or the crank position signal. also check the fuel filter it may be clog.

Jan 02, 2009 | 1995 Chevrolet Blazer

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides