2004 acurs tl hid headlights dont work

SOURCE: my headlights only work when

The headlights run thru the multifunction switch, turnsignal switch. this is your most likely culprit.

SOURCE: 2002 Acura TL low beam headlight

How to Shift my headlight beam from position.
from I replace my headlight it's spatting directly on the ground..What can i do to change it from position

SOURCE: Replacing HID headlight in 2004 Acura TL

HID Bulb Replacement

A transient high tension (25,000 V ) occurs at the bulb sockets of the high intensity discharge (HID) lamps when the combination light switch is turned ON, it may cause serious electrical shock or electrocution if you do not observe the cautions below.

CAUTION:

• Never turn on the combination light switch before fitting the HID bulbs to their bulb sockets and completing the reassembly of the headlight assembly.
• Do not service the headlights assembly in wet conditions, such as rain or snow, near a sprinkler system, or when your hands are wet to prevent electrocution.
• Do not touch the surface of the HID bulbs with your bare hands and do not stain it with any oils and fats.
• Do not disassemble the inverter unit and the ignitor unit.
• Do not turn on the HID bulb by using a power source other than the battery mounted on your vehicle.

1. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the XM radio channel preset. Make sure the ignition switch is OFF.
2. Turn the combination light switch OFF.
3. Disconnect the battery negative cable, then disconnect the positive cable.
4. Remove the headlight assembly.

1. Remove the Torx bolt using a Torx T20 bit.
2. Turn the cover (A) 45 ° counterclockwise to remove it from the headlight assembly.

1. Turn the socket (A) 45 ° counterclockwise to remove it from the bulb (B).
2. Pull the retaining spring (C) away from the bulb then remove the bulb.
3. Make sure the bulb harness (D) is routed correctly so it does not contact the reflector (E).
4. Install the new bulb in the reverse order of removal. Make sure the notches in the bulb align with the tabs in the headlight.
5. After reconnecting the battery, enter the anti-theft codes for the radio and the navigation system, then enter the customer's XM radio channel presets.

SOURCE: passanger headlight bulb inop

disconnected the HID ignighter. used a T20 to remove bulb cover. pulled out bulb and installed new bulb. DO NOT TOUCH THE BULB WITH BARE HANDS!!!

sheiden9

• 87 Answers
• Posted on Apr 11, 2009

SOURCE: HID BULB REPLACEMENT 2003 ACURA TL DRIVER SIDE

heres the procedure I uploaded it for you click [b][i]HERE[/i][/b]