Question about 2006 Jeep Wrangler

1 Answer

New Fog Lights Won't Work

Put in new head lights and fog lights...but new fog lights won't work. Put back in old fog lights and they don't work either now.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 512 Answers

Check fuse 19 in the fuse blocks under the hood...there is also a relay for the fog lights

Posted on Dec 24, 2008

3 Suggested Answers

  • 75 Answers

SOURCE: Low Beam Lights Won`t Work

you need to change the dimmer switch it has gone out

Posted on Mar 09, 2009

davidkay61
  • 23 Answers

SOURCE: Fog Lights won't work

Definitely a ground. Clean everything with light sandpaper. Follow any/all wires and see where it grounds, clean there too. If all else fails, run a new ground wire from the frame to the exact spot you got the bulbs to work (a workaround that usually remains permanent on my cars!).

Posted on Dec 01, 2008

blueextc3221
  • 15935 Answers

SOURCE: I put in new head

test + wire @ foglamp to verify 12VDC
Trace +wire to fused link.
Check fuse.

Posted on Dec 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 Olds Aroura headlights go out periodically. I pull the highbeams on and they light as long as I keep tension on the lever. Lights go back on after tinkering around with the fog light button.


may be the fog lights are the problem if moving that switch makes it work. If you have fog lights wired through the head light relay then the over load system is cutting in the same as if you had a short. For maximum benefit from the use of fog lights they should only be used on their own and never in conjunction with other lights (road authority legal requirement) . They should be mounted as low down as possible and their intended design is to shine under the fog cloud ( in the free fog zone -fog is always about 12 inches clear of the ground) and not be refracted back by the fog. If other lights are on at the same time all you see is a white blankness.

Jan 25, 2014 | 1999 Oldsmobile Aurora

1 Answer

Fog lights don't work


there is a fuse and or relay for this. You just have to find out which blank spot it is.

Dec 30, 2012 | 2008 Dodge Ram Pickup 3500

1 Answer

My head lights don't work after replacing the bulbs what could be the problem


Hi Ghost, Have a look at the head lamp relay. I believe you'll find the problem there. Regards John

Aug 06, 2012 | 1998 Audi A4

1 Answer

GMC Envoy 2003 SLT only the parking lights and fog lights work. The low beam and high beam don't work. Please help


Well, the problem is that I dont know the reason, you should investigate. There could be issues with lamps (must get new) or electricity problems (must head to auto-service)

Jun 29, 2012 | 2003 GMC Envoy

1 Answer

How to replace a front fog lamp


  • If your fog lamp is connected to or behind a grille, pop it out. This can be done by first removing the clips or screws connecting it to the car and gently pulling it out. (If your fog lights are not connected to a grille, proceed to step 2.)Find the bolts that hold the fog lamp in place; you may have to get underneath the automobile to do so.Using your ratchet wrench, remove the bolts.4Grab the connector on the back of the fog lamp, turn it counter-clockwise and pull it out. This should remove the actual light bulb from the lamp fixture.Remove the fog lamp from the car and place the new one in.6Place the light bulb into the new fog light and turn clockwise to lock into place.Bolt the fog lamp back into place, if you had to remove the grille, put it back now and screw/clip it back into place.Turn on the fog lights and make sure everything is working properly


  • Oct 02, 2010 | 2004 Ford Explorer

    1 Answer

    How do u change a bulb in the fog lights on a


    The fog lights on most vehicles sit directly underneath the headlight bulbs. The ballast and wiring work just like the headlights, so changing them takes not much time. The procedure to change the fog light is as follows:-- 1) Open the hood and reach down underneath the headlights to unplug the electrical plug from the fog light assembly. Squeeze the top of the release tab and pull the connection off the bulb's ballast. 2)Turn the fog light counterclockwise to remove it from the fog light housing. 3)Install the new fog light bulb.Then connect electrical plugs properly. 4) Test the fog lights by turning it ON. Thanks. you can rate this solution and show your appreciation.

    May 20, 2010 | 2003 Ford Focus

    1 Answer

    Put new bulbs in fog lights, now fog lights wont come on. 98 cadi catera. replaced old bulbs with new halogen bulbs now neither fog light will come on


    Halogen bulbs are brighter and generally draw more current than standard filament ones.
    Have you check that the supply fuse has not popped ?

    Jun 21, 2009 | 1998 Cadillac Catera

    1 Answer

    Low Beam Lights Won`t Work


    you need to change the dimmer switch it has gone out

    Mar 09, 2009 | 2002 Pontiac Grand Am

    1 Answer

    Fog Lights won't work


    Definitely a ground. Clean everything with light sandpaper. Follow any/all wires and see where it grounds, clean there too. If all else fails, run a new ground wire from the frame to the exact spot you got the bulbs to work (a workaround that usually remains permanent on my cars!).

    Aug 07, 2008 | 2002 GMC Sierra

    Not finding what you are looking for?
    2006 Jeep Wrangler Logo

    Related Topics:

    757 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Jeep Experts

    yadayada
    yadayada

    Level 3 Expert

    61037 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    6812 Answers

    Are you a Jeep Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...