Question about 1997 Mazda 626

1 Answer

OBD II Location 07 Mountaineer

I can't find my OBD II plug on my 2007 Mercury Mountaineer!

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 231 Answers

I'm going to take a guess and say likely to be in the passenger compartment. Sometime, they are near the glove box. You can also look under the driver side compartment. There should be a plastic protective cap. Use a flashlight.

Posted on Dec 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power liftgate will not open with remote, instrument panel control or button in rear cargo on lincoln mkx


It can be faulty switch or its issue with lift gate latch.Its got stuck up hard or cracked inside.It has to be inspected.-----------
There are few help links with proper solutions for these problem.I suggest you to refer the links.
Click the link below:----
2007 Mercury Mountaineer: Liftgate will not Unlock or Open? http://whoisbyme.blogspot.in/2012/06/2007-mercury-mountaineer-liftgate-will.html
------------
Adjust Hydraulic Lifters? http://schematicsdiagram.blogspot.in/2012/04/adjust-hydraulic-lifters.html
-----------
How to open rear lift gate? http://repairhelpcenter.blogspot.com/2011/12/how-to-open-rear-lift-gate.html

--------- Power Liftgate Shuts Down http://whoisbyme.blogspot.in/2012/07/power-liftgate-shuts-down.html
------------ Power Lift Gate Will Not Remain Open http://whoisbyme.blogspot.in/2012/07/power-lift-gate-will-not-remain-open.html
----------- Power Lift-gate will not Operate http://whoisbyme.blogspot.in/2012/07/power-lift-gate-will-not-operate.html
------------- Liftgate will Not Stay Up Open? http://whoisbyme.blogspot.in/2012/07/liftgate-will-not-stay-up-open.html

---------------- Rear Door will not open http://whoisbyme.blogspot.in/2012/07/rear-door-will-not-open.html
------------ 2000 Toyota Corolla: Rear Door wont open from outside or inside? http://whatisbyme.blogspot.in/2012/05/2000-toyota-corolla-rear-door-wont-open.html

--------------

These details will help.
Thanks.

Nov 25, 2012 | 2007 Lincoln MKX AWD

1 Answer

Location of dtc codeS mercury mountaineer


it is an obdII code reader. the plug that the code scanner ,reader, is under the dash next to the hood release latch its a black plug just to the left

Aug 06, 2012 | 1997 Mercury Mountaineer

1 Answer

My OBD port is not working on my mountaineer and i went to change the fuse for it and there is no fuse on that Location on the fuse panel..just wondering if this is normal. 2000 mercury mountanieer with...


sometimes you have to wigle the OBD 2 connector on the tester. Sometimes, you have a tool that does not communicate with your OBD 2 system. Go to Autozone and have them do a free scan to see if their tester works.

Fuse 17, 25 amp, yellow in dash fuse panel supplies 12v

PIN 16 Orange, lower right I think is 12v all the time.

Jul 27, 2011 | 2000 Mercury Mountaineer

1 Answer

07 mountaineer awd front end noise more from driver side. Sounds like the drivetrain. What should I look for.


Check the front drive shaft u-joint, and front cv shafts on the front axle, may be worn and need to be replaced. These parts will make a clicking or popping noise may sound like a thud sound.

Mar 19, 2011 | 2007 Mercury Mountaineer

1 Answer

1999 Mercury Mountaineer 'check engine' light came on after a very cold night. checked oil and antifreeze. oil was 2 qts low and antifreeze was to the top. light won't go off


Fill oil up until the check engine light goes off. If it doesn't go off by itself, have the codes scanned by an OBD-II Scanner for 1996 and up vehicles. Then, if there aren't any significant codes, erase the codes using the OBD-II Scanner.

Jan 19, 2011 | Mercury Mountaineer Cars & Trucks

1 Answer

Stumbles on acceleration check engine light is on how do i get code read out


It is an OBD II car. Autozone will read them for free. Possible some other local shops will too.

Sep 09, 2010 | 1997 Mercury Mountaineer

1 Answer

1997 Mercury Mountaineer What is Catalyst Efficiency Below (Bank


it means the catalyst is worn out, the efficiency is monitored by sensors, when the Cat falls below a certain reading or "threshold" the code is generating telling u that u need a new catalytic converter.

Feb 18, 2010 | 1997 Mercury Mountaineer

1 Answer

Cabin filter location mercury mountaineer


There is one for the 2003 Mercury Mountaineer. If you are smellign a "vinegar" odor, mix a solution of 1 part bleach to 3 parts water and pour it down the grid at the base of the windshield. It will take care of the smell.

Jul 08, 2009 | 2003 Mercury Mountaineer

2 Answers

2002 mercury mountaineer 4.0 starter relay location


The power distribution box is
located in the engine compartment.
The power distribution box contains
high-current fuses that protect your
vehicle’s main electrical systems
from overloads.
The starter relay is in position #56 of that box.

Mar 23, 2009 | 2007 Mercury Mountaineer

Not finding what you are looking for?
1997 Mazda 626 Logo

Related Topics:

325 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...