Question about 2004 Chevrolet Suburban

1 Answer

I think I have a blown fuse on my 2004 Suburban

I tolk my 2004 Suburban to the car wash and they ran both of my elecrtic seats all the way forward to vacuum. Upon completeting the wash cycle teh attendent that move the caqr to the dry area noticed that the electric seats would not move. I tried the seats and the elctric heat in the seats and noticed there was no power. ZI figured they had blown a fuse. I have check both fuse panels in the car and the main power distribution center under the hood however I have not been able to point out the origin of the power disconnect. I have also checked all plug in terminals under the seats. Do you have any idea. This has to be something simple fore the seats were working fine before.

Posted by on

  • 1 more comment 
  • 3pomsand1 Feb 14, 2009

    My 1992 Chevy Suburban Dr Power Seat stopped working. I can not find any fuses that are blown or wiring messed up. What can cause this to happen? jerry

  • Anonymous Mar 21, 2009

    same problem. passanger seat moved all the way foreward and it won't move agian. any hints to the problem?

  • tommy_elam Apr 27, 2009

    seats wont move and heated seat both on drivers side cant find which fuse it is to evev check



1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

At the back of the outer seat adjuster rail is a connector. Sometimes the conn comes apart or wires break or wires get shorted and trip the seat circuit breaker or fuse. This will happen on either side of seat. Also make sure nothing was stashed under the seat to cause wires getting caught & pulled out.

Posted on Dec 26, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I repair the drivers power seat

Sounds likely that either the fuse has blown, the connector underneath the seat has come unplugged, or the wires under the seat have been severed. (Most likely a blown fuse.)

May 12, 2015 | 2005 Chevrolet Suburban

1 Answer

2004 suburban driver 6 way seat will not go up and down but will go forward and backward

there is 2 power seat motors in that seat 1 must have gone out take to repair shop and check voltage of both motors

May 28, 2010 | 2004 Chevrolet Suburban

2 Answers

Both 12 way seats do not work on Suburban looked at fuse block

they might a relay for them,thats gone bad,, hope this help

Aug 13, 2009 | 2004 Chevrolet Suburban

1 Answer

The driver seat will not slide back or forward

checkm the fuse box for a blown fuse hope this helps regards Jim

May 14, 2009 | 2004 Chevrolet TrailBlazer

2 Answers

Fuse location for 2004 suburban

If it has blown, then chances are the pumps shot. Same thing happened on my 01 Tahoe.

Fuse is in the box on the drive fender. I believe it was a 10, 15, maybe 20 (as I recall, it was yellow). I don't remember the marking, but it didn't say fuel pump. Maybe something like APRS1 and APRS2. Something like that.

Jan 22, 2009 | 2004 Chevrolet Suburban

2 Answers

The drivers seat is stuck. It won't move forward or backward but all other seat functions work fine. hi and please help..I have the same problem with the driver will go up and down and the back...

I'm assuming this is a power seat. If so, there are separate motors that control the various functions of the seat such as forward/backard, recline, lumbar support, etc. It could be that the motor or an electrical connection to the motor for the forward/backward motion is faulty. Normally all of the motors would be on the same power circuit, so if some of the functions are working then it is probably not a blown fuse.

Just one other personal observation, I have actually seen an instance where some loose pocket change had spilled under the seat and a quarter had become wedged in the track that the seat slides in and had jammed the tracks so tightly that the seat would not move.

One thing to note is whether or not you hear anything when you try to move the seat forward/backward. If you hear a click or a buzz when you press the button then that could mean that something is physically jamming the seat tracks. If you don't hear anything when you press the button, then that more than likely means a problem with the motor or the electrical connection to the motor.

Jan 10, 2009 | 2004 Infiniti I35

2 Answers

Ran out of gas (2002 Suburban 1500) Put some in and now won't start. Help!

First check your fuel pump fuse. If it is ok,then. You will need to replace your fuel pump. The pump is in the gas tank and uses the gas to keep it cool.

Jul 26, 2008 | 2004 Chevrolet Tahoe

Not finding what you are looking for?
2004 Chevrolet Suburban Logo

700 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

82322 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides