Sliding door won't completely close
SOURCE: kia sedona outside door handle replacement
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to get to remove the bolts securing the outer handle on
SOURCE: need to replace water pump in2005 kia sedona
The kia sedona water pump is an internal pump and needs to be replaced with timing belt service. if it is leaking, then you need to change the timing belt as well. probably not something you want to do in the back yard and will run you between 400 and 600 depending on your location and shop.
Visit my Blog
SOURCE: how many ignition coils hava a kia sedona??????
6 ignition coils, one for each cylinder. 3.5 SFI DOHC.
SOURCE: Kia Door Handle
Remove the door trim inside by loosen 3 bolt with screw driver, then pull out the door trim, after that loosen the hex.bolt (3 hex-bolt) on lock mechanism bracket, after that you can loose bolt (4 hex bolt) on handle cover. Be careful to not drop the bolt, because the gap on sliding door is too narrow. After you removing the handle assembly you can see where is the broken. You can remove the handle from cover by removing pin clips on it. To fixing the broken handle you can just using plastic glue or you can drill a small hole and put some small wire to reinforce the plastic.
SOURCE: 2007 Kia Sedona van power sliding door
i just had to have this fixed on my 07 sedona on the bottom arm for the doors there are litle lock solinoids that go bad i would take it to a dealer to have it checked for the switch you can turn the power off to the doors and open them manualy but they are hard to open because you are pulling the cable instead of the motor doing it and this will not hurt the doors
1,299 views
Usually answered in minutes!
×