Question about 1999 Ford Windstar

1 Answer

Clicking sound 1.There is a clicking sound as long as  the key is in the run position. its seem to be behind the radio.  2.The heater does not work. also the lever you slide from cold to heat seems to be not connected to anything (slides freely)

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 659 Answers

There is an actuator motor that controls the heater door, when these go bad they make a clicking noise. If the clicking stops or pauses when you change the heat from hot to cold the actuator needs to be replaced. There is no cable on the temp control it is electrical.

Posted on Dec 24, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change a turn singal switch


Remove or Disconnect
1. Make sure lever is in center of OFF position.
2. Electrical connection behind lever.
3. Switch lever by pulling straight out.

Install or Connect
1. Make sure switch lever is in center of OFF position.
2. Switch lever after aligning tab.
- Push straight in.
3. Electrical connection.

Inspect
- Test operation.

Nov 10, 2013 | 1998 Chevrolet Lumina

1 Answer

2004 sebring will not start no radio


have you checked all the fuses.? how did it run before this? it sounds to be a few things. first pull the starter and have it tested . the fuse box is also a control module . they have problems going bad

Dec 19, 2012 | 2004 Chrysler Sebring Sedan

2 Answers

Heater temperature slide lever not working


The motor for the blend door is broke.
The blend door controls the direction of air thru the heater core and the evaporator.

Sep 05, 2012 | 2000 Ford Windstar

1 Answer

1998 ford e350 turn signal flasher clicking when key is on and lever is in the center position but no lights flashing until lever is pushed up or down then signals work as should replaced signal switch...


1) Is it a tilt column?

2) Do you use the tilt feature?


Sounds like it's in the column, which is very common for Fords around this time.

You can also expect to eventually have to push the column shifter up into the park position (even though it's in park), to start the vehicle; have to pull the shifter towards you to use the overdrive cutout function, and all kinds of fun stuff like that.

Sep 02, 2012 | 1998 Ford Econoline

1 Answer

The 2003 impala will not start / you turn the key and nothing happens. the door locks do not work / the heater does not work/ and there is a clicking noise in behind the glove box. the battery is brand...


no start and door locks are consistent with security system activation. Is your security light blinking? Are you using the factory key with the resistor on the blade? Do you have another factory key you can try?
Not sure why the blower would be affected. Does the radio work? If not, check the radio fuse inside the car, as I think it runs the blower controller. Also check the HVAC fuse under the hood--#29--this one affects the security light.
I think the body control module is behind the glove box, but not sure why it would be clicking in these circumstances.
Let me know what you find out and if you have questions along the way.

jturcotte_642.gif


jturcotte_643.gif



jturcotte_644.gif


jturcotte_645.gif

Dec 27, 2010 | Chevrolet Impala Cars & Trucks

2 Answers

My 1999 Ford Windstar, the heater is Not blowing Hot air, the Fan is working. Where is the Thermostat located??


the thermostat is in the thermostat housing. that is the end part of the upper radiator hose, where it connects to the engine. assuming the car is otherwise running OK it is not your problem, replacing it is a waste of your time. most likely the heater core is shot, that is where you should be looking. it sits within the heater box which is most likely behind the dash under the glove box, over the passenger footwell.

Nov 18, 2010 | 1999 Ford Windstar

1 Answer

Can not get my trunk open by lever inside or key lock on trunk lid and I am using the right key. Trunk lock seems to be in open position.


The lock latch is held by a spring to be in Normal Close position. It it is in open position then there is 2 possible root causes: 1- The cable pulling the latch to open gets stuck. 2- The spring broken or out of its position. Hope this can help to fix it.

Nov 19, 2009 | 1994 Toyota Camry

1 Answer

Cruise Control, Steering Wheel Radio Buttons, Overhead Console


it sounds like you got 2 problems...the cruise and radio buttons sound like a bad clockspring......the overhead console problem sounds like a bad ambient temp sensor located behind the grill. if it is too cold out the ac will not run

Oct 28, 2008 | 2000 Dodge Caravan

2 Answers

I cant get the key out or lock steering column and the automatic transmission shift lever locks up in park. Now if I take the battery off every thing works fine. This sure seems like a reset problem.I run...


I cant get the key out or lock steering column and the automatic transmission shift lever locks up in park.
Now if I take the battery off every thing works fine.
This sure seems like a reset problem.I run the car by not having it in the locked column position and get the shifter to work by putting a key in the hole furnished
by chevy to bypass shift lock. thank you

Sep 15, 2008 | 2006 Chevrolet Aveo

2 Answers

Ford windstar


This is a heater vent motor.

About $84.00 from dealer, pain in the *** to change behind the radio, but worth doing it yourself.

Sep 03, 2008 | 2002 Ford Windstar Cargo

Not finding what you are looking for?
1999 Ford Windstar Logo

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...