Question about 1988 Ford Bronco II

1 Answer

I have spark, does not start.

I backed the 88' Bronco out of the garage. Parked it. Went out later to start it. It has spark (tested a spark plug wire). Acts like it is not receiving fuel. Turns over very easy, almost like there is no compression. Not even a bark.

Thank You.

Gary

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Sounds like it has jumped time.

Posted on Dec 25, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

88 toyota camry....drove car...parked it....when I went to start it lil later it just turned over but wouldnt fire....checked spark at plugs and had spark...fuel pump is working...even used starting...


Depending on how long it sat you may have either a weak spark (which will not start the combustion) or a timing issue. The timing belt may have slack, caused by a loose tensioner.

Jul 13, 2014 | Cars & Trucks

1 Answer

The malfunction indicator light came on about a month ago in my Suzuki Alto (2005) and I took it to the garage and was told there was a misfire in cylinder 2. I was told it was fine so they reset the light...


If the code has been a misfire in the same cylinder every time, the problem is very likely the ignition coil for that cylinder. When the ignition coil first starts to go, the malfunctions will be sporadic and therefore difficult to troubleshoot. The ignition coil can be tested for resistance on both primary and secondary windings in the coil to prove it is failing.

Oct 30, 2013 | Suzuki Alto Cars & Trucks

2 Answers

88 bronco turns over but wont start?


i would test the fuel pressure. it sounds like the fuel pump or control circuit have some issues

May 12, 2017 | 1989 Ford Bronco

1 Answer

88 ford bronco v8 engine cranks but w/n start


distributer cap may be corroded inside or ignition module coulda failed--computer mite be worn after 23yrs-pull plug and cleanit--the same with fuel pump--try to get a mobile scan guy----------parts places have troublshootn books as well as library ---dont replace parts till u kno the solution-or u can git frustated and broke

Oct 19, 2011 | 1988 Ford Bronco II

1 Answer

My 1996 ford bronco wont start. My wife drove home from work parked over the weekend and was going to work on monday and it wont start it turns over fine and its getting spark but idont hear the fuel pump....


i would start simple on this and check the fuel pump relay first. there not that expensive you can try to replace if you cant find specs to test it. if that does not work then i would say its your fuel pump that went out.

Jun 23, 2010 | 1996 Ford Bronco

1 Answer

Randomly won't start, happened after jumping dead battery


Probably the battery. Take it the chain auto parts place and they will test it for you.

Aug 29, 2009 | 2007 Mazda B4000

1 Answer

Engine wont start!


Have you checked for spark?

Mar 19, 2009 | 1988 Ford Bronco II

2 Answers

Weak spark + 1988 ford bronco


check the voltage of the b+ terminal of the ignition coil (primary side) with a cheap multimeter while cranking. low voltage to the primary will cause low voltage on the secondary. also recheck all ground paths from the ignition module. ensure good connection from coil to module. note: new parts are not "known good parts" until it runs.--> IG.MOD.

Dec 17, 2008 | 1994 Ford Bronco

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

81294 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...