Question about 1994 Dodge Caravan

1 Answer

Heater was working then quit

I had the radiator flushed and new cap. still was cold for a day/. then next day drove it on highway 10 miles and worked.

Posted by on

  • nervewrecker Jan 10, 2009

    1992 dodge grandvoyger. heater will not blw heat.

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

Check fluid level again. Sounds like air pocket.

Posted on Dec 23, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What's your problem? emissions not ready


****** your timing so it barely runs and have it tested again, i had to do this on a built motor i had in a pickup a while ago and it worked then. not sure if the testing standards have changed alot since but its an idea.

Mar 19, 2012 | 1998 Chevrolet S-10 Pickup

3 Answers

Have 2000 VW Beetle heater not working. Had a flush done and replaced thermostat. At first thermostat would not open but after quite some time running it did open and began blowing rather warm but not hot...


It is very possible that there is air in the Heater hoses and it needs to be "Burped". With the engine COLD, remove the radiator cap and locate the Heater core hoses (there will be 2 hoses close together - In and a out). It is also possible the thermostat could be installed backwards.

Nov 16, 2017 | Cars & Trucks

1 Answer

Heater blowing cold air replaced thermastat next day heater blowed hot then it started blowing cold again has a new radiator and the water is not low


Flush coolant system out first with prestone or peak coolant flush if problem still exist replace heater core.

Apr 05, 2011 | 2001 Chevrolet Blazer

3 Answers

Hi my name is Heath. I have a 1990 Ford Bronco. The other day after i drove it home, I pulled in the driveway and turned the engine off. I got out and heard a hiss so i opened up the hood and I saw brown...


A flush and a thermostat is never a bad idea, but it sound like your radiator cap is worn out, not holding pressure, replace it, should have a 16 lbs rating radiator cap.

Aug 23, 2010 | Ford Bronco Cars & Trucks

3 Answers

What could make my 03 civic ex overheat and cool down then overheat again while losing heat inside??? Already replaced radiator, water pump, thermostat.... motor


your heater has apparently restricted the coolant flow....hopefully a good system back flushing will cure the problem....use a flush obtained from a parts house....I would buy the hose kit for flushing as well...good luck to you

Mar 04, 2010 | 2003 Honda Civic

2 Answers

2000 Dodge Ram Heat not hot, only luke warm @ idle only 105 deg. @ 1500 rpm. So far this is what i've done and tried: Changed Thermostat with 192 deg oem repl. Changed radiator cap unhooked both heater...


did you use pure antifreeze if so remove it all and add a 50/50 mixture because antifreeze will not heat up good if its pure. needs water to allow good heat.

Jan 05, 2010 | 2000 Dodge Ram 1500 Truck

1 Answer

No heat just warm air


I think you are on top of your problem,,you dont need any one elses advice.
Complete rebuild of the cooling and heating system,, simple.

Jan 19, 2009 | 2001 Oldsmobile Alero

1 Answer

Oil pressure light comes on after driving on highway for 10 miles


Sounds like your sending unit sensor - if it was your pump going out, your engine would be history by now. Rule of thumb, if your oil check light ever comes on, it's usually too late to remedy the problem. You have a major issue, but since you've obviousely drove it quite a bit since then and it still hasn't seized up, I'm guessing you're ok...for now. Since you took it to a shop and they said you're ok, I'm assuming they checked your level and visually checked for leaks and found nothing. Either, you've got somethijng partially blocking your pick-up tube for the pump which is in your oil pan, or a electrical issue with the sensor. I would start by having someone check the sensor out and go from there...good luck.

Dec 29, 2008 | 2002 Jeep Liberty

3 Answers

Chevy S10 overheated, now heat doesn't work, leaking coolant


When an engine is overheating and then the temp drops on the guage, it's usually a sign that the coolant is not touching the temp sensor. There's no coolant in the engine. Putting water in the overflow tank won't solve this. Take the radiator cap off after the engine cools and put coolant in the radiator. you might have to crank the engine and do this several times, as the engine can develop air pockets that won't allow the coolant to travel inside the engine. If you don't see any leaks, and it still uses coolant, you've probably got a blown head gasket. Check for water on the plugs, check cylinder compression. If it slowly uses coolant, try putting a large box of pepper in the radiator or some of that radiator seal copper flakes.

Dec 22, 2008 | 2001 Chevrolet S-10

Not finding what you are looking for?
1994 Dodge Caravan Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

82322 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...