you have one on the inside of each wheel.
SECTION 206-09A: Anti-Lock Control
2002 Lincoln LS Workshop Manual
REMOVAL AND INSTALLATION
Front Wheel Speed Sensor
Material
Item
Specification
RTV Silicone Sealant
FSTZ-19G204-AB (Canada CXC-114A)
NAVSTR Sealer
Removal and Installation
- Raise and support the vehicle. For additional information, refer to Section 100-02 .
- Position the inner splash shield aside.
- Remove the pin-type retainers.
- Position the inner splash shield aside.
- Disconnect the anti-lock brake sensor electrical connector.
- Remove the anti-lock brake sensor harness from the brake hose clips.
- Remove the anti-lock brake sensor.
- Remove the anti-lock brake sensor clip.
- Remove the anti-lock brake sensor.
-
NOTE: Make sure the anti-lock brake sensor is fully seated before installation of the new clip.
To install, reverse the removal procedure.
- Apply a 2.5 mm (0.1 in) bead of silicone sealant to the outside diameter of the anti-lock brake sensor.
-------------------------------------------------------------------------
Rear Wheel Speed Sensor
Removal and Installation
- Raise and support the vehicle. For additional information, refer to Section 100-02 .
- Disconnect the rear anti-lock brake sensor electrical connector.
- Remove the rear anti-lock brake sensor harness from the control arm clips.
-
NOTE: Clean off dirt and foreign material that may have collected around the rear anti-lock brake sensor before removal.
Remove the rear anti-lock brake sensor.
- Remove the anti-lock brake sensor bolt.
- Remove the anti-lock brake sensor.
- To install, reverse the removal procedure.
×