Question about 2000 Chevrolet 2500

2 Answers

Starter starts while engine is running

I replaced starter relay and starter it ran fine all day. but after i started it to warm up this morning.i came out and starter was runing.new starter now shot.

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 14,036 Answers

Sound like starter drive gear still engaging or stuck .

Posted on Apr 13, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 44 Answers

Make sure the battery wire from the starter isnt tuching the s wire on the silanoid and have the battery check

Posted on Apr 08, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Diesel glow plug relay


the heading is diesel glow plug relay and then you go on about a choke and petrol inplug holes
what have you got a diesel engine or a petrol engine

May 17, 2017 | Cars & Trucks

1 Answer

2003 infinity i35 won't crank. good battery


If the ignition switch is good and you are certain it works fine,did you realize there is a TSB for this condition when ever you replace a infiniti starter or even some Nissan you are supposed to replace the starter relay also,but it goes further than that you also need to rplace the Throttle control relay with the starter relay.8_7_2012_4_44_55_am.gif

Aug 07, 2012 | Cars & Trucks

1 Answer

Nissan pulsar '88. replaced starter motor, then


Is it a manual, or an automatic? Earlier Nissans sometimes have a problem with the neutral safety switch (a device that keeps the engine from rolling over in gear or without the clutch depressed.) Generally, if their bad, they need to be a little warm before they'll start, like setting in the sunlight for a few hours.

Good Luck!

May 22, 2010 | 1988 Nissan Pulsar

2 Answers

I have a 2002 Saturn Vue, 2.2L. We replaced the engine, and the car has been running fine for the past 2 weeks. We got up this morning, started the car, let it warm up, ran a few errands, had no issues at...


have you check the starter? sounds like that is the issue. if the click from the fuse box is the starter relay then you are most likely getting signal to the starter. try to bang on it with a metal pole while some one turns the key radipidly. let me know what happens.

Mar 27, 2010 | 2002 Saturn VUE

1 Answer

P1320 code appeared and we replaced the cam position sensor. It ran OK, but started rough until warm and next code showed #1 cylinder misfire. Replaced #1 coil and it ran great. Then later the engine light...


i just had the same problem in my bmw 325i. Probably vaccum leak or exhaust leak. Check that nothing came loose in these areas. It takes time for your car to learn the new CPS (cam pos. sensor) so give it a few days and reset the code again and see if it works.

Mar 12, 2010 | 2000 Nissan Maxima

1 Answer

Hard starting after engine warmed up. Starts


Check and/or change plugs and wires...or relocate starter relay to inside engine bay...cheers.

Jan 16, 2018 | 1996 Cadillac DeVille

2 Answers

Car was running the day before. Next morning, got


Try having one person turn the key to the start position and hold it there, while someone else taps on the starter with a hammer. If tapping on it makes it work, you need a starter. Good luck. Hope this helps.

Jun 07, 2009 | 2002 Ford Taurus

2 Answers

Engine turns over fine , car will not start.


well the first part of your question i was all ready to tell you to put a new fuel pump in, now not so sure, there is a relay for fuel pump, can you hear pump cycle and relay click? relay under hood you will have to listen close they don't run long maybe a couple secounds, if you don't relay bad. if you do pump could be bad, do fuel pressure test pump could be weak. don't think sunroof and turn signals are related, but stranger things have happend.

Jan 25, 2009 | 1998 Honda Odyssey

Not finding what you are looking for?
2000 Chevrolet 2500 Logo

Related Topics:

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

82188 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...