Question about 2006 Mercury Mariner

1 Answer

Seeking location of windshield washer pump on 2006 Mercury mariner

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

On top of fire wall towars the back i believe

Posted on Dec 23, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the 2006 mercury mariner reverse switch located?

Assuming a V6 and A/T, the reverse lamps relay is located in the smart junction box.

Oct 14, 2016 | 2006 Mercury Mariner

1 Answer

Where Is the windshield washer pump located on a 2006 Suzuki ?

More often than not the washer fluid pump is located at the bottom of the washer fluid reservoir. You may need to remove a few things to see the reservoir, but at the bottom there should be an electrical connector that goes to the pump.

Jan 30, 2016 | Suzuki Cars & Trucks

1 Answer

What fuse location does the Auxiliary Power Point use on a 206 Mercury Mariner?

Assuming your Mariner has a V6 and is not a hybrid, 20A FUSE 12 in the battery junction box (BJB) supplies 12 volts to the power point.

Sep 21, 2014 | 2006 Mercury Mariner

1 Answer

Windshield washer line broken

Its a special part..available from a Ford dealer. Fitting it means taking off the old one, and carefully noting how to put a new one back!

Mar 18, 2014 | 2008 Mercury Mariner

1 Answer

Replace windshield washer fluid tank?

Thanks for choosing FixYa and welcome. Most tanks are built similar and mounted similar. It should be located on the firewall. This is the back wall in the engine compartment. It is held up by bolts. Check the top and it may have one on the bottom also. You may have to remove some parts before it will come out, possibly the battery or air hoses. I haven't changed one on the Mariner, but they all are similar. It is only held up by 2-4 bolts. You may have to unplug the water level sensor. I hope this helps. They are easy to change. It all depends on what you have to move for it to slide out. Take care. If you have any questions, just post back.

Jul 23, 2011 | 2006 Mercury Mariner

2 Answers

How do you access the windshield washer pump on a 2006 buick lucerne

The washer pump is located on the bottom of the wash fluid bootle. you can access it by removing the front passanger fender liner..

Dec 11, 2009 | 2006 Buick Lucerne

1 Answer

Mercury villager 1994 washer pump not working

the pump motor likely is bad. get a used washer fluid reservoir at a pick n pull yourself or at page with * is lowest cost.

Pump and Reservoir, Windshield Washer Removal
  1. Disconnect the battery ground cable (14301).
  2. Raise and support the vehicle.
  3. Remove the RH wheel (1007).
  4. Remove the RH front fender splash shield (16103). Refer to Section 01-02 for the removal procedure.
  5. Remove the windshield washer reservoir top bolt.

  6. Disconnect the windshield washer reservoir fluid level sensor electrical connector.
  7. Disconnect the rear window washer pump electrical connector from the rear window washer pump.
  8. Disconnect the windshield washer pump electrical connector from the windshield washer pump (17664).
  9. Place a suitable drain pan under the windshield washer reservoir (17618) and drain the washer fluid.
  10. NOTE: The rear window washer hose end is color-coded, matching the connector on the rear window washer pump. Match the colors to ensure proper installation.

    Disconnect the washer hoses from the windshield washer pump and the rear window washer pump on the windshield washer reservoir.

  11. Loosen the two windshield washer reservoir side bolts.
  12. Remove the windshield washer reservoir by sliding it out of the side slots.
  13. Remove the windshield washer pump.

To install, reverse the removal procedure. Tighten the lug nuts (1012) to 98-118 Nm (72-87 lb-ft).

Sep 09, 2009 | 1994 Mercury Villager

1 Answer

Need to find the computer module on the 2006 Mercury Mariner

Located on passenger side. Tou need to look under the dash then turn to look under the console. You will see a black box PAT unit around 8 or 10 inches long with fairly large numbers printed on its side. These are the 5 numbers you will need

Jun 07, 2009 | 2006 Mercury Mariner

Not finding what you are looking for?
2006 Mercury Mariner Logo

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts


Level 3 Expert

67800 Answers


Level 3 Expert

5367 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22011 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides