Where is the ect located on a 1999 kia sportage

Greg Bernett

• 2993 Answers
• Posted on Jul 26, 2009

SOURCE: 1999 kia sportage timing marks

Crankshaft match marks


Align marks on timing belt pulley and pump body.

Camshaft pulley alignment marks

1. Align marks on camshaft pulleys with alignment marks on seal plate.
2. Install timing belt. NOTE: No looseness should exist on the tension side and at the camshaft pulleys.
   
3. Loosen tensioner lock bolt.
4. Turn crankshaft 2 revolutions in direction of rotation and check that timing marks are still in alignment.
5. Tighten timing belt tension lock bolt to 27-38 ft lb (32-52 Nm).
6. Apply a force of 22 lbs to timing belt between camshaft sprockets.
7. Belt deflection should measure 0.30-0.33 in (7.5-8.5 mm)
8. NOTE: Replace tensioner spring if timing belt deflection is excessive.

1. Install lower timing belt cover.
2. Install upper timing belt cover.
3. Install power steering drive belt and adjust belt tension.
4. Install fan pulley.
5. Install generator drive belt and adjust belt tension.
6. Install A/C drive belt and adjust belt tension.
7. Install splash guard.
8. Install fan and fan shroud.
9. Install 4 fan bolts. Tighten to 24 ft lb (33 Nm).
10. Install fan shroud mounting bolts.
11. Install fresh air duct.
12. Connect hose to resonance chamber.
13. Connect battery negative cable.

SOURCE: i dont know where to add freeon to my 1999 kia sportage 4x4

Find the A/C compressor. Look a both lines going to it. One line should be bigger than the other. The bigger line is the Low Side (suction port) follow that line it goes to the firewall to the evaporator that is in your dash. The low side pressure port is somewhere in that line between the evaporator and the compressor. That port is where you check low side pressure and add freon. Don't worry if you buy a charging kit from a part store you can't hook it up wrong, the low side port and the high side port are different sizes and the hose won't fit. With the A/C running on high, low side pressure should be about 35psi.

SOURCE: A 1999 Kia Sportage. Heater core leaking.

tie both hoses together

SOURCE: 2000 Sportage: where is the spark plugs located on a 2000 Kia Sp...

They are under the black plastic cover that is in the middle of your valve cover gasket. Remove the intake hose from the aluminum intake plenum on top of the valve cover and the silencer box against the firewall. Remove all the connectors from the sensors which should be 2 on the plenum and the 2 large vacuum hoses on the plenum. Then remove the 3 12mm bolts from the plenum at the throttle body and remove the plenum. You can reuse the throttle body gasket at the plenum so don't destroy it. All the other bolts are 10mm and use a screwdriver to loosen the clamps on the hose. The sensors have clips that you need to remove with a small screwdriver, then disconnect them. Remove the bolts on the cover and the cover. Then remove the bolts holding the coil packs down. Do one plug at a time. 2 of them are connected to the 2 plug wires and 2 are underneath the 2 coil packs. The connectors on the coil packs are fragile so remove them carefully. Reverse the steps to reinstall the plenum, etc.

Ronny Bennett Sr.

• 6988 Answers
• Posted on Jun 10, 2010

SOURCE: location of crankshaft position sensor on 1999 kia

The crankshaft sensor is in the bell housing,near the flywheel.If this was helpful,please rate,thank you