Question about 1991 Saturn SL1

1 Answer

I'm trying to get the battery out of my 2001 Saturn SL1.

The cables oare off but I can't lift the battery and can't find any bolts or clips . Where are they situated?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

If you look at the battery from the top, you will see on the side closest to the fender (away from motor) that there is a bracket that runs along side the battery. It is very hard to notice. You need to take a 10mm socket with a 6" or longer extension, and remove the nut that is on top of it, right at the bottom inside edge of the battery. This may be hard to see, and hard to get to. Unfortunately, that is the only way to remove the battery on that car

Posted on Dec 23, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 saturn sl1. foot slipped off clutch petal while shifting from drive to reverse, now stuck in neutral. Could it be broken fork? expensive? thanks


if the pedal feels normal and you can't shift it into gear when the engine is off then check the shifter cables where the fail is next to the clip that holds the outer section to the transmission case

Aug 11, 2012 | Saturn SL1 Cars & Trucks

1 Answer

Replacement instructions for a starter on a


1. Raise the front of the car and support on jack stands.
2. Remove negative battery cable.
3. Crawl under the car and locate the starter.
4. Remove 13 mm nut securing power cable to the starter and pull cable to the side.
5. Remove 10 mm nut securing the ignition wire to the solenoid and pull wire to the side.
6. Using a ratchet with a 13 mm socket and 6" extension, remove the 2 bolts securing the starter to the transmission.
7. Remove starter.

Installation is reverse of removal.

Oct 01, 2009 | 1993 Saturn SL1

2 Answers

Need to replace the altenator on a 2001 saturn sl1 1.9 liter twin cam


1)Remove serpentine belt from above with 14 mm wrench on spring
loaded idler pulley.
2)Disconnected battery
3)jack up car and remove passenger front wheel
4)it helps to also remove the wheel well splash panel also for better
access.
5)crawl under car and remove battery and other connectors from the
alternator. then remove lower attachment bolts (I think there are 2
below to deal with-one is for a support bar, and one is an alternator
attachment bolt)
6)go back up to top of car and remove upper attachment bolt (this one
is a little hard to get to)
7)pull alternator out and have a alternator shop repair bad rectifier
board and any other items that need attention.
8)reinstall repaired alternator
9)leave splash cover off to provide additional cooling to the
alternator area. put wheel back on and lower car.
10) install new serpentine belt from above and reconnect battery.

If you have the time you could get the newer improved alternator from
6th planet. It has shields to improve the heat disipation.

Thank you Sir, Have a nice day.

Sep 20, 2009 | 2001 Saturn SL

1 Answer

How do you change an egr valve on a saturn sl1 2001


Quite easily take off the air breather tube then there is a cone shaped part with a connector on top at the back of the engine right by the accelerator cable 2 10mm bolts hold it on take off the 2 bolts and the valve comes off. If your still not sure you can buy a new EGR valve or if your going to just clean it to save you some money, you can use Carb cleaner which you can get at Auto Zone and they can give you the step by step instruction's free of charge to replacing the EGR valve  on you car with common tools. Good luck 

Sep 16, 2009 | 2001 Saturn SL

2 Answers

1999 Saturn SL1 manual...shifter cable bushing


Hello:
NAPA sells the replacement bushing ($20) better than Saturns $200 to replace both cables.
Good luck

Jun 20, 2009 | 1999 Saturn SL

1 Answer

Saturn 1997 SL1, step on gas after a stop sign , the car wouldn't go ... then Air Bag light came "ON", followed by Fuel Light , and final dies ...


sounds like your alternator is not charging.I would have that checked first.Also check battery terminal bolts/ cables

May 07, 2009 | Saturn SL1 Cars & Trucks

1 Answer

Trying to remove the starter on a 1991 SaturnSL


no there is not a special tool need more info go to collisionrepairadvice.com for more
1991 Saturn SL L4-1.9L DOHC VIN 7 Vehicle Level a_003366.gif Starting and Charging a_003366.gif Starting System a_003366.gif Starter Motor arrow1.gif Service and Repair arrow2.gif blnk_spc.gif Service and Repair Notes
  1. Disconnect battery ground cable.
  2. Remove air inlet tube and fresh air hose, on DOHC models, lift resonator upward to disengage from engine support bracket.
  3. Remove upper starter attaching bolt through access hole near intake manifold support bracket.
  4. Raise and support vehicle.
  5. Using suitable pliers, remove starter shield pin, then lift shield upward to release from solenoid.
  6. Disconnect starter electrical connectors and position aside.
  7. Remove lower starter attaching bolt.
  8. Remove rear starter support bracket attaching bolt.
  9. Rotate starter until bracket clears axle shaft support bracket, pull rearward toward lefthand side of vehicle to remove.
  10. Reverse procedure to install. Torque starter attaching bolts to 26 ft. lbs., starter bracket bolts to 22 ft. lbs. and starter solenoid terminal to 3 ft. lbs.

Apr 11, 2009 | 1991 Saturn SL1

2 Answers

Egr valve on a 2002 Saturn SL1


Take off air breather tube,you should see a cone shaped part, on top and at back of engine right by the gas pedal cable. Remove the 2 10mm bolts, and it should come right off.

Mar 16, 2009 | 2001 Saturn SL

2 Answers

1996 saturn sl1


should be left off tranny under neather air box no sure though best way 2 find it is to follow your plug wires where they end is you coil pack.

Jan 25, 2009 | Saturn SL1 Cars & Trucks

2 Answers

How do you remove the transmision valve body on 2001 saturn


You must remove the Trans pan, the valve body is inside the trans case under the pan, I would not suggest you do this job unless you have a high degree of technical skill, there are check balls and other factors that if not done right will cause the trans to not work properly.

Jul 28, 2008 | 1993 Saturn SL1

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

690 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...