Question about 2001 Dodge Neon

1 Answer

Fuse sign light on when start my car

This morning when I started my car sighn"fuse" came on(where is milage shown)for 1 min. and disepiared.2 mechanic could not find any bad fuses.Sign come on every time i start and it's gone in 1 min or so.

Posted by on

  • Anonymous Jan 20, 2009

    could a locked steering wheel have something to do with bad fuses? I have had the fuse light turn on when car first starts too. Help!!!!!!!!!!!!!

  • twilabegaye Jan 20, 2009

    I have to same problem too. Could this have anything to my car not starting. The steering wheel is locked and so is the iginition will not turn also.



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Dodge Master
  • 753 Answers

Hi my name is Allen!

Normally this means you have a fuse blown!

This year model neon had a lot of problems with the instrument cluster circuit boards, its hard for me to say thats what it is without being there to check it.

If this is not causing problems I would just drive it until it comes on all the time then check the fuses again, it could be a fuse thats trying to go bad, you know like a light bulb that will flicker for awhile and then burn out.

For further assistance contact me at FixYa!

Posted on Jan 01, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Ford F650 6.0 Nightmare!! Won't start, error code 221 Internal sensor voltage supply. fault mode Id:4 voltage below normal or shorted out! Help

Modern electrical issues can only be resolved only after all connections have been determined as clean, dry, and tight. Corrosion can cause voltage drops that will affect sensitive sensors and relays, that will prevent your vehicle from starting. Loose connections and especially an entire fuse box being loose will definitely be part of the problem. Repairs to this need to be done to continue diagnosis.

Jun 14, 2014 | 2007 Ford F-650

1 Answer

Hyundai tuscon

You have to carry out the dark test on your vehicle. Disconnect your earth cable from the battery. Connect a test light from the neg pole of the battery to the end lead of the test light to the neg terminal wire side to test light so that you have a test light with light on. Wait approx 5 min for the convenience system to shut down. The test light should now glow dim if not start by pulling each fuse out till the test light goes dim. Look at fuse box cover to see which system is staying on. That's were your problem should be.

Apr 03, 2014 | 2008 Hyundai Tucson

1 Answer

Crank, no start on 1994 honda accord EXi

you might need a fuel pump relay under dash 10 min fix/and your d4 flashing light bad transmission.

Mar 05, 2014 | Cars & Trucks

1 Answer


Look for a poor connection on the fuse link bundle.

Sep 07, 2017 | 2007 Toyota Corolla

1 Answer

Fuel pump fuse keeps blowing on my 95 Crown Vic

Using a smaller fuse should make the problem happen more often.
A mechanic would unplug the pump harness at the tank and check the circuit for high resistance or a short to ground.
If nothing is found in the harness, I would suspect the pump in the tank.

Jul 19, 2012 | Ford Crown Victoria Cars & Trucks

1 Answer

Fuse light flashing on my milage gage

you have two problems both bad your oil pump is going out, and your trans is about to go out also. both very expensive if you can trade or sell car soon.

Jul 15, 2012 | 2001 Dodge Neon

1 Answer

Just bought this 1999 tahoe from my brother in law and out of curosity i went through the fuse box and realized a 10amp fuse was missing from the fuse box which read security so the person that i am i put...

You need to reset the Passlock security system to your Tahoe.

1. Attempt to start the car, let it stall, but DO NOT turn the key off! Leave it in RUN.
2. Wait 10 minutes or until the Theft System light glows steady instead of blinking.
3. Do not turn the key off, but start it immediately.
4. This should reset your Passlock system.

Good luck and thank you for using Fixya.

If that does not work then your may have to do the 30 min relearn. You do basically the 10 min thing with the security light trick instructions above. Here goes this only works if your secuity light is on.

Put key in ignition don't start the car but you want to turn the key all the way on and release it back to the on position wait 10 mins or till the security light stops flashing repeat this the exact same way two more times( dont take key out) ending in about 30 mins total time. this should reset the code to the computer and you should have no more problems with it.

Nov 24, 2010 | Chevrolet Tahoe Cars & Trucks

1 Answer

My light will not turn on to see my milage. Is it a fuse or maybe a light balb. I dont know where to start.

start with fuse then if its ok go to the bulb.if both are fine look for the power relay.

Jul 01, 2010 | 1999 Buick Regal

1 Answer

Fuse keeps popping - 20A ENG CONT 1

Before replacing fuses try disconnecting neg battery lead first. If still blows look loose wire under motor

Dec 14, 2017 | 2000 Nissan Maxima

2 Answers

Sebring won't start

could be your powertrain control module. Something is draining your battery. I had this problem. Make sure you don't accidentally leave the trunk open (drained 2 batteries this way, then replaced my car with areally expensive battery, but still had a problem. Turned out to be the PCM. IF you have a 2001 2.7L V6, this is located between the air filter housing and the fuse & relay centre. Its that silver heavy duty looking thing strapped in between the air filter housing and the fuse and relay centre. Replacement of this should be done by a qualified mechanic because 1) your airbags will have to be disabled and 2)you will have to make sure that there is no electrostatic discharge - which could damage this little brain system. Good luck

Aug 08, 2008 | 2001 Chrysler Sebring

Not finding what you are looking for?
2001 Dodge Neon Logo

Related Topics:

141 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

83054 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides