Thought it was the battery, but it is at 12.67vdc, tryed to jump it, but it didn't help, got the old solinoid out and it works when i connect it to a battery, is there something they may have but on the car to prevent it from turning over, I know on some of the older GM vehicles they put a low oil switch on the car, any suggestions??
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
How about the start solinoid? Try jumping the large terminals with a large screw driver and see if it turns over if so make sure there is 12 volts on the coil of the soinoid when you turn the key, if so replace the solinoid.
A simple jump start with battery cables should get the car started and recharge the battery. If you don't like dealing with battery cables, there are products that attach from inside the car using the cigarette lighter to jump start the car that work very well.
solinoid for starter is bad. on a lot of fords the solinoid is mounted on fender, under hood. if you jump from one side to other on solinoid, and it tries to start then solinoid is toast. just follow the positive cable from battery. and you will find it.
it could very well be the starter solinoid mounted on fender under hood. most fords are setup this way. to test it --
could use jumper cable to jump the two large studs on the solenoid together,
which should make the starter crank the engine, assuming the engine can rotate
freely. If jumping the solenoid works, then the solinoid is probably bad. have a good day !!
The problem is either the starter solinoid (located on fender near battery) or you are not getting power to the "s" terminal on the starter solinoid from the ignition switch. If you follow the positive battery cable from the battery you'll follow it to the solinoid. Remove the small wire from the terminal marked "s" on the solinoid and using a screwdriver jump from "s" terminal (not the wire) to where positive battery cable connects to solinoid. (with battery connected). If starter doesn't do anything the solinoid is bad. If starter cranks then you are not getting voltage from ignition switch through "s" terminal wire.