Question about 1994 Chevrolet S-10 Blazer

1 Answer

2006 trailblazer 4x4 dash switch.

The switch broke off in my hand and now the car is in permanent 4 hi. Any suggestions as to where I may buy replacement knob?

Posted by on

  • Ellen511 Jan 11, 2009

    I have the same problem on my 2006 trailblazer. The knob broke off but with part of the inside shaft. How do I fix this?

  • mmpp20 May 11, 2010

    Have you checked with your local Chevy dealer? They may or may not offer just the knob. You may have to purchase the whole switch assembly..



1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

How to replace the 4x4 selector on an 04 envoy

Posted on Feb 23, 2014


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 61 Answers

SOURCE: 2006 chevrolet trailblazer tire pressure

you normally have different psi in the front than the rear is because of the weight difference.

Posted on Mar 24, 2009

  • 56 Answers

SOURCE: 2005 Trailblazer no 4 wheel drive.

usually the actuator will still make the light still come on if its bad I would check the actuator

Posted on Jan 02, 2010

  • 323 Answers

SOURCE: 06 Trailblazer clicking noise and 4x4 issues

clicking noise is the CV joiint

Posted on Jan 16, 2010

  • 246 Answers

SOURCE: 2006 chevy trailblazer replace 4wheel drive selector

i've got a 2003, and i believe the parts and procedures are the same for the years. there are screws in the dash trim by the ciggarette lighter, and more on the underneath of the dash pad where the gauge cluster is. then carefully pop the dash trim out. there are retaining clips that hold it in besides the screws. they should pop out without too much effort. i'd start near the radio and be careful. there also may be two more screws near the bottom of the steering wheel that you'll have to remove the trim below it to get at.

Posted on Feb 17, 2010

  • 501 Answers

SOURCE: programming replaced master door switch 06 trailblazer

No. not the switch. Check to see if you have power going into it. I don't have the wire diagram, but you can take a test light and check each line. At least one will light up with the key on. Certainly check your fuses.

Hope this helps

Posted on Apr 09, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 06 Chevy trailblazer and the 4wd/auto switch is gone and it has been jumping from 4wd to auto . What do I do to fix it, I don't think a new switch is the fix

Most likely the control module assembly is the problem. It can be located under the dash and sometimes behind the passenger kick panel cover. You will normally hear a click noise when you engage the 4x4 and this click noise will indicate the location of the controller. You may not be able to access 4x4 hi if the lights are flashing but 4x4lo usually works.

Apr 25, 2015 | 2006 Chevrolet Trailblazer

1 Answer

Can I bypass the 4x4 switch in the dash and still get it in 4x4 h

Why would you want to do that? Do U know that that is your problem? What about the shifter motor on the transfer case (encoder Motor) or the control modum? If it is the switch, U can buy & replace it W/O any problems because that is the easiest of the 3 to replace. NO, U can't shift it W/O the switch, I know, just went thru that..... GOD BLESS.....

Feb 26, 2015 | 2002 Chevrolet TrailBlazer

1 Answer

2006 trailblazer indicates 4 lo but is in 2 wheel drive

Switch may be bad. Change switch should fix it.

Mar 13, 2014 | 2006 Chevrolet Trailblazer

1 Answer

Trailblazer 4 wheel drive

the trouble could be expensive or it could be as simple as a broken vacuum hose on an actuator or a broken wire.. The risk is are you paying too much for a known fault in a vehicle that may cost big dollars . How badly do you want this car and can you afford the big dollars to repair it . Work out why the car is being sold

Jan 21, 2014 | Cars & Trucks

1 Answer

I have a 2002 Trailblazer the 4x4 switch on the dash don't light up any more which means the 4x4 don't work any help

I appreciate your request for my help. However, for either personal or technical reasons I am unable to assist you at this time.

Dec 05, 2011 | 2002 Chevrolet TrailBlazer

1 Answer

I have a 2002 trailblazer the 4x4 switch on the dash is not lite up and the 4x4 don't work any help

Try to locate a blown fuse in your fuse block first. Could be a simple problem. Check the fuse first.

Dec 05, 2011 | 2002 Chevrolet TrailBlazer

1 Answer

My 4X4 won't shift into 4Lo but it will shift into 4X4 Hi and anti 4X4,. What could be the problem? It's on a 2004 Chevy Trailblazer.

On some GM vechiles with 4x4, you have to put tranni in netural, then try to shift into low 4x4. Same thing when you're done with 4 low trying to go back to 2 or 4 hi.

May 30, 2010 | 2004 Chevrolet TrailBlazer

1 Answer

Fourwheel drive components

if it is a 4x4 the switches are on the dash board in frot of you, in order
2 HI , 4 HI ,4 LO

Dec 27, 2008 | 2004 Chevrolet TrailBlazer

Not finding what you are looking for?
1994 Chevrolet S-10 Blazer Logo

Related Topics:

362 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

83810 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides