Question about 2005 Ford Escape

Open Question

Disarming anti theft system for 2005 ford escape

Light on dash is on car wont start

Posted by on

  • yadayada
    yadayada May 11, 2010

    lock and unlock the drivers door, if that doesn't do it u need to take it to the dealer.

×

4 Suggested Answers

  • 625 Answers

SOURCE: anti theft device for 97 ford expedition

you need to call a lock smith guy most of they have the machine to do it. or call arrown to se what shop has a ford scan tool
it has to be a scan tool only to do fords.

Posted on May 28, 2008

  • 3 Answers

SOURCE: 2001 ford taurus wont start and anti-theft light is blinking

Either you may be using a key that you had copied from the original or your chip went bad in your original key. Most of cars now a days have the key censor in the key so if it is the incorrect key it will not start your car or if it does not read that chip it will not start

Posted on Feb 05, 2009

junmag
  • 175 Answers

SOURCE: anti theft device for 1997 ford expedition

try using a spare key first

Posted on Jun 02, 2009

dcramer531
  • 1654 Answers

SOURCE: Anti-theft indicator keeps flashing when

Yes it flashes to let others know you have an alarm on the car and not to mess with it! Yes. It should blink when the key is not in the ignition. This lets you know that the Passive anti-theft system is on. What this means? Basically the key you use has a specific code that coordinates with your car, and that key is the only key that will work for your car out of a possible 70 quadrillion codes or something like that. The light is used to help scare away thiefs that would break into your car, no car alarm will go off if they do, but most run of the mill car thiefs wont take the chance of breaking into your car if they think there might be an alarm on it. If the light blinks while the key is in the ignition then you shouldn't be able to start the car. It's normal for it to always flash. The only time it won't is with the car running.
If this was helpful a vote with the thumbs up would be greatly appreciated.
Thanks

Posted on Aug 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the antitheft reset box for a 2002 ford taurus


Bobby, Ford Taurus anti theft system reset procedure. reset button below driver side dash. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
How do you reset securiLock anti theft system on 2003 Ford Taurus
How do disarm anti theft device on 2001 ford taurus
https://answers.yahoo.com/question/index?qid=20081101221926AAKSS8V

Aug 27, 2016 | 2002 Ford Taurus

1 Answer

How do I bypass anti theft on 2004 Ford explorer


There is no reset button on an OEM system. Instead of trying to disarm the anti-theft, arm it, then start the car. Press the "Lock" button on the key fob, put the key in the ignition and see if that works.

Feb 27, 2016 | 2004 Ford Explorer

2 Answers

How to reset anti theft on a 2005 ford five hundred


[PDF]Ford Passive Anti-Theft System Relearn ... - Cardone

my.cardone.com/techdocs/PT%2078-0004.pdf
Passive Anti-Theft Systems (PATS), also called Ford Securilock, is a vehicle security ... Module (PCM) on a PATS-equipped vehicle, a parameter reset or relearn ..

Ford Focus No Start Theft Light Blinking Easy Fix - YouTube

? 9:25
www.youtube.com/watch?v=pJBMgrW7MQU
Feb 12, 2014 - Uploaded by FordTechMakuloco I'm having that issue now with my 2005 Ford Explorer any other ... I am having alarm problems so I never ....

Oct 30, 2015 | Ford Cars & Trucks

1 Answer

CAN ANYONE HELP ME WITH THE NAME OF A ELECTRONIC PART ON THE FIREWALL OF MY FORD ESCAPE XLT 2001. IT HAS A RED LIGHT THAT FLASHES


On the firewall or do you mean top of the dash ? Do you have a little red light that flashes on the top of the dash ? That is the anti-theft system warning indicator !

Jun 13, 2015 | 2001 Ford Escape

1 Answer

Why is red light on dash with lock/key symbol flashing


Theftlock/passlock whatever ford calls it. It is their anti theft system. The system provides a link from the computer to the key itself where a chip tells it that it is indeed the correct key. If your key isn't working you likely need to do a pats relearn procedure. Guessing you lost all power or replaced a battery or a pcm

Oct 11, 2014 | 2005 Ford Escape

1 Answer

1994 ford explorer limited anti-theft


Two tips:
* If your anti-theft system is sounding (horn honking/lights flashing)you press the panic button on your key fob to shut it off.

* If your anti-theft system is armed (but not triggered) it is disarmed when you unlock the door(s) using your unlock button on your keyfob, the key pad on the driver's door, or your key.

Hope help with this. Good luck (remember rated this).

Feb 25, 2010 | 1994 Ford Explorer Limited

1 Answer

2003 ford escape +theft light disarming can you help light is flshing can not shift in to gear with out pushing the hidden push botton car runs


the theft system keeps the car from starting. you likely have a problem with the interlock solenoid (they do fail) thats why the manual release. Use a volt meter to check for voltage withe the key on and your foot on the brake. if 12volts is present, the solenoid is bad.

Dec 09, 2009 | 2003 Ford Escape

1 Answer

Replaced the alternator, now anti theft won't disable


The ignition lock anti-theft switch (19A438) detects if the ignition key cylinder is broken or "slam pulled" during a theft. The ignition lock anti-theft switch is always monitored by the remote anti-theft personality (RAP) module. This allows the alarm system to be triggered in the case that the ignition lock anti-theft switch detects tampering of the ignition key cylinder (even in the event that the alarm is not active at the time).
Refer to the Section 501-14B for more details on the keyless entry remote transmitter (15K601).
The door open warning lamp switch (14018) communicates to the RAP module through the generic electronic module (GEM). This input to the RAP will cause the anti-theft alarm to be sounded if the anti-theft alarm was armed.
The door disarm switches are assembled into both LH and RH lock sets. The door disarm switch must be triggered before the mechanical lock unlocks. This is to prevent the anti-theft alarm from activating when it should have been disarmed.
The RAP module controls the anti-theft system and is the brains of the keyless entry system. The RAP module communicates with the GEM to request that the interior lights be turned ON/OFF with use of the keyless entry remote transmitter, and the GEM communicates to the RAP to inform when the door is opened. Refer to Section 418-00 for inter-module communication.
The RAP module has three wire connectors attached to it:
  • The antenna for the keyless entry remote transmitter.
  • 26 circuit connector (C256).
  • 22 circuit connector (C257).
In addition to the perimeter alarm that uses the door open warning lamp switch, the RAP module also uses the ignition lock anti-theft switch and the autolock/relock feature to prevent theft of the vehicle. For a full description of the autolock/relock system, refer to Section 501-14B .
The THEFT LED is found on the instrument panel between the tachometer scale and the needle pivot point. The LED is illuminated during prearming and flashes when armed or triggered.
Prearming and Arming the System
The system can be armed if:
  • The ignition is OFF.
  • The PANIC alarm is OFF.
  • All doors are closed.
There are two ways to prearm the system:
  • Press the LOCK button on the transmitter.
  • Open a door, press the power door lock button and close the door.
After 30 seconds the system will be armed and the theft indicator in the cluster will flash every two seconds.
Disarming an Untriggered System
An armed system will be disarmed with one of these valid actions:
  1. Pressing the UNLOCK button on the transmitter.
  1. Placing a key in the door and turning to UNLOCK.
  1. Turning the key to RUN or ACC.
The anti-theft alarm can be triggered by the following conditions:
  • The ignition cylinder is damaged with or without the RAP being armed.
  • A door is opened without disarming the armed RAP module.
The remote transmitter can activate a panic alarm which is similar to an anti-theft alarm, but does not deactivate the starter or cause the theft indicator to flash.
Disarming a Triggered System
If the system has been triggered, (the horn honks, the lights flash, and an external starter interrupt relay is engaged), the system can be disarmed by:
  1. Pressing the UNLOCK or PANIC button on the transmitter.
  1. Putting a key in the door and unlocking the door.
  1. Turning the ignition to RUN/ACC (Turning the key to RUN/ACC will not disarm an alarm that has been triggered by the ignition lock anti-theft switch.).

Apr 10, 2009 | 1997 Ford F150 Regular Cab

Not finding what you are looking for?
2005 Ford Escape Logo

Related Topics:

943 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...