Question about 2001 Chevrolet S-10

1 Answer

Blower motor swap

Will a blower motor from a 99 chevy malibu fit into a 01 Grand am?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 61,168 Answers

They are the same part number, so yes they will interchange.

Posted on Dec 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace blower motor system pack on 2001 chevy malibu


first, remove the lower right dash insulator panel from below glove box. slide bcm aside for access to blower motor.(slide to right). remove 3 screws from blower housing, pull blower motor and fan straight down. if putting in a new motor, use cage from old blower. the resistor for fan speeds is located beside motor. good-luck!!

Jul 29, 2010 | 2001 Chevrolet Malibu

2 Answers

Blower motor not working


blower motors sometimes dont last for ever,i have a chevy blazer and have replaced the blower motor 4 times so far, i get mine from my local car salvage yard,brand new mine goes for 100$ or so, i pay 10 buck's a pop,can't beet that price,plus mines only a 5 minute swap, i'm still ahead if i figure the 60 or so buck's in my pocket,plus i'm warm when i put the switch all the way to the letter H, junk yard's your best bet,just get it from a newer grand-am,and make shure the holes line up.

Dec 20, 2009 | 2000 Pontiac Grand Am GT

1 Answer

Replace blower motor resistor unit on 99 Malibu ?


the blower motor resistor is below glove box. remove panal under box. slide the pcm out of the way, resistor is beside blower motor. unplug wiring, take out screws holding it in then pull straight out to remove.

Jul 10, 2009 | 1999 Chevrolet Malibu

2 Answers

Where is the blower motor resistor on a 2003 Chevy Malibu


Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.

Mar 18, 2009 | 2003 Chevrolet Malibu

2 Answers

I'm looking for the location of the resistor on the blower motor of a 99 pontiac grand prix


If it is the same as a 2002 Grand Prix the resistor is located on the firewall behind the blower motor up under the glove box. You need to remove the blower motor to get to it.

Mar 12, 2009 | 1999 Pontiac Grand Prix

1 Answer

Location of the Heat resistor in a 2003 Chevy Malibu?


Under the glove box, behind the blower motor itself. Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.

Feb 24, 2009 | 2003 Chevrolet Malibu

1 Answer

Blower motor


call local junk yard to be sure... they have books on cross referencing parts fitability.....but my thinking is yes

Dec 22, 2008 | 2001 Chevrolet S-10

2 Answers

I have a 2001 Chevy Malibu LS 6-cylinder and my heater blower stopped working. I checked the fuses and they are all good, I assume the motor for the blower is bad. I believe the blower is a 1997 - 2003...


Replace the blower motor resistor. Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.

Dec 17, 2008 | Chevrolet Malibu Cars & Trucks

1 Answer

Blower or resistor on 99 malibu?


the resistor gmpartsdirect.com usualy has good diagrams or go to the libruary n get a service book

May 16, 2008 | 1999 Chevrolet Malibu

Not finding what you are looking for?
2001 Chevrolet S-10 Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...