Question about 1992 Chrysler New Yorker

1 Answer

Switch will turn on things but will not turn the car over.

Turn the switch and everything works but will not turn the car over to start it. What can I do to get it to start?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

Have you tried contacting the Chrysler dealers. If you have not you probably should. I think that they will no whats wrong with the car.

Posted on Dec 22, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1994 pontiac sunbird;i turn key on everything inside works.turn key over i get nothing


could have faulty starter or starter solenoid.hook test light make you a test light with longer wires and 12 volt bulb with socket go junk yard find good bulb with socket.hook test light to starter and see if test light lights up if so your starter or starter solenoid has a open winding. if test light dont light up could have blowed fuse to transmission neutral switch or neutral switch could be bad.try to start vechicle in neutral if vechicle starts your transmission neutral switch out of adjustment or neutral switch faulty check make sure wires going to neutral switch is damaged.

Sep 09, 2012 | 1994 Pontiac Sunbird

1 Answer

Key turns everything on but will not turn starter


A mechanic would check for voltage at the neutral safety switch.

Aug 16, 2012 | 1999 Ford Expedition

1 Answer

Turn signals do not work but everything else works even the emergency flashers


I have found a lot of these turn signal switches bad but check fuse 27 if ok This is a tip turn key one and put turn signal switch in the left or right postion, then push and release the 4 way switch at least 10 times if at any time the turn signals start working while the 4 way switch is off the turn signal is bad. What happens is the contacks in the switch pit and buy working the 4 way switch a bunch of times it scraps through the pits. If they do start working change the switch this isn't a fix its just an easy way to pin point a common problem. If that did work here are the complete test.

326caaa.png7954492.pngc51c094.png48332bd.png

Oct 20, 2010 | 2002 Ford F250 Super Duty SuperCab

1 Answer

2000 Chevrolet Silverado 1500 LT V8 (smaller V8) 4WD Tow Package. Truck won't start, LED message board works, radio works, lights work, can turn key to 1st position and everything lights up but when...


Sounds like the trailer towing might be a fluke occurance I would say that you Igntion switch may have a burnt contact inside it.I have replace alot of these at my Garage.

Jul 31, 2010 | Cars & Trucks

1 Answer

Car won't start, battery is fine. No indication of any problems, returning from funeral car won't turn. All lights, radio everything else works fine.


May be neutral safety switch, put into neutral and try to start. If that works have switch replaced its on the transmission. Even if it starts that way it wont take long before the car wont turn over in that position.

Jun 04, 2010 | 1995 Mercedes-Benz S-Class

1 Answer

Anti system light is off.


if you mean your theft system is on try to turn car over leave switch on with lights on with antitheft blinking leave it for 15 to 20 minutes.turn switch off wait a few seconds and try to start your car

Aug 31, 2009 | 2003 Chevrolet Malibu

1 Answer

Car just stop running


The ignition switch sounds like it was going bad. If you're getting power to everything else(headlights, radio) then you're battery should be good.

If your starter was going bad, then typically the light would dim, because it would try to turn the starter over and it requires a lot of power to do that.

So check those and then you've narrowed your options. Try spraying some WD-40 in the switch and try to start it that way. Sometimes when those switch give out, you can still press really hard on them and it'll engage the start circuit.

Could have also knocked your neutral safety switch loose, that is, if it's an automatic. This is the switch that prevents you from starting the car while in drive. Try starting the car in park. If that doesn't work, start the car in neutral. If that doesn't work, turn the key and hold it while at the same time moving your shifter around the neutral area. If it starts to turn over, then it's a misaligned neutral safety switch.

Feb 10, 2009 | 1995 Pontiac Grand Am

Not finding what you are looking for?
1992 Chrysler New Yorker Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

83096 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...