Question about 1994 Toyota Camry

1 Answer

94 camery will not start

Hello i have a 94 camery 4 cylinder and i have checked my starter and battery and all check out good i have also checked all the fuses and they are all good . can u please help me .

Posted by on

  • ash seder May 11, 2010

    how do you now your starter is good is the car Turing over?



1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Have you checked the fuel pump

Posted on Dec 22, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

94 GMC sierra wont start. just single click. battery checks good. Starter taken off and checked at autozone, good. all connections were tight and no corrosion on bat terminals. any ideas

Check very closely where the negative battery cable connects to the engine. Any looseness or corrosion there will prevent the full power of the battery to activate the starter. Check the negative battery cable itself to make sure it is in good condition and has no other connections than to the engine.

Oct 25, 2016 | 1994 GMC Sierra

3 Answers

I replaced my solenoid on starter yesterday. I had to take out the air intake to get to the Starter/Solenoid from underneath the vehicle. Starts great but now theres another problem. Now it stalls, the...

You have got a loose ground wire. Check the negative wire that comes off the battery and goes to the engine block. You probably messed with the +12 volt wire on the battery when you change the starter. Check the battery connections and the ground good....

If you need further help, I’m available over the phone at

Aug 25, 2009 | Ford Probe Cars & Trucks

1 Answer

1999 camery all of a sudden starter fuse keeps blowing

check battery cables for corrosion, loose or broken connections from battery to starter. for some reason starter is drawing to much power through fuse. Hope this gives you a starting point

Aug 02, 2014 | Cars & Trucks

1 Answer

2000 Toyota camery won't crank

Crank means engine does not spin. Make sure your battery terminals are clean and tight. If the starter is getting good battery power, see if your center two spark plugs are wet, crank it with those plugs removed to clear any accumulated water from a blown gasket. If you need to test your battery, listen to the sound of your horn with heater and wipers on full. Try to turn your engine a little with a socket on your alternator pulley bolt. It should move the belt very easily.
If you want to test your starter, for the 4 cylinder 2AZ engine clamp a test wire on red positive battery terminal and touch the other end of it to the terminal on your starter - the little black wire clip connector just behind that metal brace.front side of starter. The V6 engine starter is a little harder to reach.

Dec 01, 2013 | Cars & Trucks

1 Answer

My 94 subaru legacy wagon wont start. It only clicks when i turn on the key. I had starter checked and it tested good.

Hello and welcome to FIxYa!

It can be caused by a week battery. As a first course of action, I strongly suggest that you have the battery charged or have it replaced for the starter to kick fully.

Hope this helps and thank you for using FixYa! Have a good one!

Oct 26, 2011 | 1994 Subaru Legacy Outdoor

1 Answer

We turn the key on our 2002 toyota camery 4 cylinder and get nothing it has be dragging when you started it. Battery is good I can't seem to find the starter to replace it

It is next to the transmission cross member on the lower left side of the engine connected to the bell housing. It will have several havy duty wires on it. The starter selenoid is mounted to the side of the starter. .Just follow the battery cables from the battery to the relay and then on to the starter.Under neath on the drivers side.

Jul 08, 2011 | 2002 Toyota Camry

1 Answer

94 bronco 5.0 will not start changed solinoid

Remove starter wire from solenoid and firmly touch it to the other wire on solenoid. It will spark some, starter should crank if working; providing battery power is good and the battery connections are clean. Check the heavy ground wire from battery to where it's connected to the engine or body are clean. If not, starter is bad.

Jul 02, 2009 | 1994 Ford Bronco

2 Answers

Where is the starter located?

underneath the bottom of the engine next to the flywheel look at the positive side of the battery and follow that battery cable down to the starter

Feb 19, 2009 | 1994 Toyota Camry

1 Answer

94 jeep grand cherokee 6 cylinder

Check the starter, selinoid, and then the ignition switch if the motor will not turn over. If it turns over without fire check the ignition coil and then the distributor.

Aug 20, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1994 Toyota Camry Logo

Related Topics:

329 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

82285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides