An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has answered 20 questions.
Re: location of fan resistor
The fan resistor is located by the blower motor. on a 2002 and newer there is about 6 or so wires on a thin flat plug. pretty close to it. I believe it is under a little cover. I know this might not be much help but it has been about 3 years since I replaced one. I do know the wires on the plug I described earlier will melt the plug sometimes, and the control head will go bad too sometimes so it could be any of these things. so dont get aggrivated if the resistor doesnt fixit although it might.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Doesn't it work in any speed ? Could have Blower Motor Control Processor if yours has automatic HVAC .
Or if manual it has blower motor resistor . Both are located under passenger side dash . Remove insulator panel under the dash if it has one !
ORO How to replace blower motor resistor in Chevrolet Silverado
the resistor is located in bottom of heater box under right side of dash it will be close to blower motor. the wires from blower motor go to resistor. check the plug and replace it as well they tend to melt
The blower motor fan is controlled by the blower motor resistor.Its the resistor which controls the fan on respective speed which you select.But if the resistor goes faulty,then it will not be able to set the required speed which you set for fan,so it works on high speed only.
In this case you will have to replace the blower motor resistor.
Check fog for the location of blower motor resistor location:--- see part number 8 in the diagram below.
The blower motor resistor is located next to blower motor under the dash.Its fitted with 2 screws and a wiring connector.You have to remove the screws and wiring connector and take the resistor out and place the new resistor in same position and connect the connector as well as screws.
this should help.Thanks.Helpmech.
FIRST THING MAKE SURE YOU CHECK ALL FUSES UNDER DASH AND IN POWER DISTRIBUTOIN BOX UNDER HOOD LET ME KNOW TAKE TEST LIGHT SEE IF ANY VOLTAGE ON MOTOR IF SO BAD MOTOR IF NO VOLTAGE THEN LOCATE THE BLOWER MOTOR RESISTOR FOR SPEED CONTROL....COMMON PROBLEM... THIS COULD BE LOCATED UNDER DASH ON PASSENGER SIDE IN THE HEATER CORE BOX OR UNDER HOOD PASSENGER SIDE NEAR FIRE WALL...THEY ARE ALSO COMMON FOR BURNING OPEN CAUSING NO FAN
I've never seen a vehicle w/o a blower resistor. You don't need to remove the blower. The resistor is about 2 inches x 3 inches and is installed in a hole in the plenum (duct) near the blower motor. It will have a wiring harness connected to it. It could be under the passenger dash or under the hood, depending on where the blower motor is.
The blower motor resister is located next to the fan under the passenger side dash. You will have to remove the glove box and plastic cover under the dash to expose the blower motor. the resister is next to the blower motor.