Question about 1998 Ford Explorer

1 Answer

1997 ford exploro hvac blower motor does not come on

Posted by on

  • AndyK9 Apr 26, 2009

    I have the same problem; replaced the resistor (under hood, close to firewall $27)...no joy.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 66 Answers

Several reasons, but most common is the blower resistor.

Posted on Jan 04, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 ford explorer ac fan in front does not work, rear blower does work, where should I start looking for problem


Front HVAC blower motor, Heat & A/C ! Viewing wiring diagrams an testing the electrical circuit's using a DVOM - digital volt ohmmeter is how you start a diagnose's . Do you know how to do that ? It's not hard if you have right training .
Lot's of video's on youtube .
Electric Testing Techniques You Need to Know
free wiring diagrams here http://www.bbbind.com/free-tsb enter vehicle info year , make , model an engine size . Under system click on HVAC , then under subsystem HVAC controls . Click the search button ,then the blue link's . Looking at the two link's i see that your vehicle could have blower motor relay's an resistor or blower motor speed controller. Knowing what your looking for can be a challenge .
Blower Motor Resistor Function and Diagnostics

May 06, 2018 | Ford Cars & Trucks

2 Answers

Blower motor inop on 2004 ford crown vic


I looked at info for automatic hvac. I'd check for applicable hvac trouble codes, if there are any. Some of the national brand autostores will check po codes not sure about manufacturer specific codes?
Note the diagram for front blower motor, those two wires should be voltage and ground, use a test light to check. Could be problem with blower motor, itself?
blower motor-322injsxui1g2sbi1aaxs5hb-2-0.jpg

Nov 24, 2017 | Ford Cars & Trucks

1 Answer

HVAC BLOWER STOPPED WORKING


The noise can mean several things. It could be a bearing noise or something worked its way into the ductwork and jammed the motor. Without this noise, Ford products had problems with the blower motor resistor and that would be another prime candidate for failure.
You can take the blower motor out and have it benchchecked for electric problems.

Mar 19, 2014 | 2006 Ford F-150

1 Answer

Ford explorer blower motor


How do I know it's my blower motor itself, blower motor resistor or a switchbox?

You view wiring diagrams an test electrical circuits with a DVOM - digital volt ohm meter .
Free wiring diagrams here http://www.bbbind.com/free-tsb
Enter vehicle info. year , make , model an engine size , Under system click on HVAC , under subsystem HVAC controls . Click the search button ,then the blue link.
Do you know how to do that ? Videos on youtube on electrical circuit testing .

Feb 12, 2018 | 2000 Ford Explorer

1 Answer

2000 Eldorado blower not working


INFORMATION
Subject:
Revised HVAC Blower Motor Installation Procedures

Models:
1994-1997 Cadillac Seville
1994-1999 Cadillac DeVille
1994-2002 Cadillac Eldorado

The intent of this bulletin is to provide technicians information regarding the proper installation of the Heating, Ventilation and Air Conditioning (HVAC) Module blower motor (with impeller) assembly.



The current available HVAC Module blower motor for the above listed vehicles can be identified by the three mounting holes (1). The original equipment blower motor had five mounting holes.

In order to avoid confusion and ensure a high level of customer satisfaction, when replacing an HVAC Module blower motor, refer to this bulletin for the appropriate procedure.

Eldorado/Seville-HVAC Blower Motor
Caution: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

Removal Procedure
1. Disconnect the negative battery cable.

2. Remove the camshaft cover.

3. Remove the blower motor.

^ Disconnect connector from the blower motor.

^ Remove the blower motor screws (either 3 or 5 screws).

^ Remove the blower motor from the HVAC Module.

Installation Procedure
1. If present, remove the 2 ribs located on the barrier. Refer to Step 3 and the illustrations in the Instruction Sheet, P/N 52494110, found in the blower motor kit.

Important: Ensure the blower motor gasket makes a complete seal around the blower motor.

2. Install the new blower motor with heat shield. Refer to Steps 4 and 5 in the Instruction Sheet, P/N 52494110, found in the blower motor kit.

3. Install the blower motor retaining screws.

Tighten

Tighten the screws to 4 N.m (35 lb in).
4. Tighten the lower heat shield retaining screws to 4 N.m (35 lb in).

5. Connect the connector to the blower motor.

6. Install the camshaft cover.

7. Connect the negative battery cable.

Oct 09, 2012 | 2000 Cadillac Eldorado

1 Answer

Trying to find out where resister is on 1997 explorer . And how to change it.


which resistor?

I'm assuming the blower motor resistor?

if so... you'll find this inside the HVAC case but removed with two bolts under the dash

Mar 27, 2010 | 1997 Ford Explorer AWD

1 Answer

Heater fan not working


if your car has automatic hvac system then it may be the blower motor controle module or the blower motor
if it has manule hvac system it could be the blower motor resistor or the blower motor

Feb 08, 2010 | 1997 Buick LeSabre

2 Answers

Hvac blower not operating any speed,


have you tried replacing the blower resister module?

Sep 29, 2009 | 2003 Ford Crown Victoria

1 Answer

Hvac blower motor not working


replace the "blower motor resistor" located next to the blower motor

Dec 22, 2008 | 1998 Ford Explorer

Not finding what you are looking for?
1998 Ford Explorer Logo

Related Topics:

639 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

81294 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...