Question about Hyundai Motor 2005 XG350

1 Answer

Engine revs when first started after that it cranks normally

Unless it sits for a long time dia on the car has p3233 but that is a 1200 dollar fix any suggestions
this a hyundai xg350 2005 out of warranty

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hyundai Master
  • 22,326 Answers

Scrapyard and take whole lot from a car thats running but smashed up ,dealers will not programme a secondhand unit been there got the teashirt ...

Posted on Dec 22, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 Toyota Corolla Long crank with cold engine normal start and operation after warm engine


hi, i would like to advice you check the electronic idle speed control valve and also check engine coolant temp sensor. The ISC (idle speed control valve) is located somewhere below the throttle valve. the engine coolant temp sensor is located near distributor. it has a two wire connection. the sensor connector is usually green

Oct 25, 2017 | Toyota Cars & Trucks

1 Answer

I have a 2010 bmw 328i xdrive sometimes it cranks and starts perfect but on occasions it cranks but does not start.


Hi there I am a mechanical technician engineer I fix the things normal mechanic cant! I fix mechanical and electric problem no matter what it is the problem with it!!!I I am very good and bless in my work I am 5gen mechanical engineering technician never have a problem I can not fix Its the ignition switch also have to check out the grounds for the whole car do a voltage drop test to find out the problem

Oct 25, 2015 | 2010 BMW 328i xDrive

3 Answers

2002 mazda 626 crank no start


Try just turning the key over three times and listen for the fuel pump running without turning the motor over. Then on the fourth attempt let it try and start. If it starts then, replace psi regulator.

Dec 05, 2013 | Cars & Trucks

1 Answer

Intermitten starting issues with 1993 Mazda MX5 Miata


Sounds like a heat sensitive sensor--either the crankshaft or camshaft unit. Is the check engine light on? If so, rent a scanner, read any code(s), and pursue to repair(s).

Sep 30, 2009 | 2000 Mazda MX-5 Miata

2 Answers

My nissan 350z sometimes stalls after starting


after i replaced the battery in my 2003 350z, it would stall immediatly after i cranked it on unless i gave it a little gas. I fixed this by cleaning the MAF and throtle body valve. Total supply costs were $15 and took about 20 minutes. My Z is not only fixed but runs smoother and cleaner.

Jul 11, 2009 | 2003 Nissan 350Z

1 Answer

My daughter's 1990 Honda Civic occasionally will not start. It cranks fine, but it will not turn over. Usually, if she waits anywhere from 5-15 minutes, trying to start it every few minutes, it will crank...


if the car just wine's when starting like it would normally and nothng is happening...Check for fuel, either find the fuel pressure relief valve near the rear of the engine, and depress the valve stem (fuel should hit the roof of hood) if not then its a fuel problem, try this a couple times, but turning the key over, and listen for noise from the gas t ank to see if the pump is actuating.. if you hear the noise while just turn the keyy to acc, not start plz comment back that you hear it , but its still doesnt start....
hope this fix's-ya!

May 19, 2009 | 1995 Honda Civic

1 Answer

Chrysler 3.5 won`t rev past 2500 rpm?


remove the aircleaner intake hose and, check the intake air control flap for free movement

Apr 22, 2009 | 2002 Chrysler 300M

1 Answer

Rebuilt engine 5.7 l 1998


I broke down and purchased a new crank shaft sensor . It cost $15000 hated to spend it because everbody told me they just don't fail , and why would it when it worked fine before the motor was rebuilt. IT FIXED IT.

Feb 03, 2009 | 1999 Chevrolet Silverado 1500

Not finding what you are looking for?
Hyundai Motor 2005 XG350 Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...