Question about 1997 Plymouth Voyager

1 Answer

1997 Plymonth Voyager horn does not work.

Also, cruise control does not work and has no power. The airbag light on dash is on.

Posted by on

  • 1 more comment 
  • exarha Dec 22, 2008

    Yes, and I scanned the vehicle and code P1698 displayed Defininition: ECM fault - No CCD message from TCM, Explanation Failed ECM, Probable Causes: open CCD bus line, and Failed TCM. These issues do not seem to be related to horn or cruise problem.

  • exarha Dec 22, 2008

    Yes, is there a particular fuse you think is the culprit? I am wondering if the wiring to a fuse is the problem.

  • Mike Butler
    Mike Butler May 11, 2010

    You have check all your fuses?

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

My van had the same problem. You need to replace the clockspring located in the steering wheel. Once replaced, the horn will work, the cruise will work, and the air bag light will shut off. Hope this helps!!! It worked for me!!

Posted on Jan 05, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Cruise controlnot working


Do you have an airbag light lit ? Are your cruise control buttons on the steering wheel . If so the clock spring could have an open circuit. A clock spring is a part inside the steering column , under the steering wheel . Check out this video on clock spring .
https://youtu.be/4jv2DW39drA if no airbag light ,then probably not this part.

Nov 23, 2015 | 2004 Chevrolet TrailBlazer

1 Answer

Cruise control not working


You need to post the make and model of your car.

Generally if the cruise control light is on, on the dash indicator then the problem is in the steering wheel electrical connection.

Then internal wiring connecting the steering wheel cruise control switch is connected to the dash by a special wire called a clock-spring ribbon. This is located under/behind the steering wheel. It is not a self service repair item and required a good deal of expertise to repair. Sorry, but you will most likely need to take it to a qualified mechanic. Because the steering wheel also contains an airbag, do not attempt to do this repair yourself!!!

j

Apr 29, 2015 | Cars & Trucks

1 Answer

Horn doesn't work,abs light on dash stays on and also cruise control does not work either


Typical reason for no cruise and horn is a bad clock spring underneath the airbag. Typically you have an airbag light on as well and not an abs light

Aug 21, 2012 | 1998 Nissan Quest

1 Answer

Cruise control quit working, so where should I check. I would like to know about the wires and fuses and where to trace them down.


The 1994-95 Chrysler Minivans have four electrical panels/fuse boxes.:
  1. Fuse Block Panel (In Dash)
  2. Relay Block (In Dash)
  3. Micro Relay Block (In Dash)
  4. Power Distribution Center (Underhood)
Fuse block is located on left side of instrument panel, behind access door. Speed (cruise) control fuse is No. 14.
Note: If you have an airbag light on your dash litup, it might be something called a clockspring, which you'll have to take to the dealership/garage to get fixed. (Dealership is probably your best bet)
Hope this helps! :)

Oct 20, 2009 | 1994 Plymouth Voyager

1 Answer

'92 Town car airbag indicator flashes, cruise control not working


you need to have a diagnostic done in order to get an error code and take it from there..

Sep 05, 2009 | 1994 Lincoln Town Car

2 Answers

Cruise control doesnt work, horn doesnt work and air bag light is on


the spider cable broke, wish is the air bag cable locates inside the steering wheel

Aug 02, 2009 | 1997 Ford Expedition

1 Answer

Horn and cruise control dont work, what to do?


It is wires wound around in a circle within a plastic housing called a clockspring. The clockspring lives behind the steering wheel and connects your horn, cruise and most importantly the airbag. Usually it is the airbag that is first to quit with a light on the dash coming on.

May 19, 2009 | 1995 Dodge Dakota

1 Answer

Airbag light is on constantly and cruise control does not work


Hey,
take a look at www.airbagmodul.com

They're working in Airbag-Simulators and Occupancy Sensor-Simulators.

Regards

Gerrit

Apr 11, 2009 | 2001 Jeep Wrangler

1 Answer

Horn,airbag light,cruise control


Sounds like a bad clockspring

Feb 27, 2009 | 2003 Chrysler 300M

2 Answers

Cruise control won't engage


most likely the clock spring is not the problem because when u push the button the dash light cruise comes on.wich means that you do not have an open circuit.with a light tester check to see if you are getting power to the cruise control servo.if you are then replace it.if no power you will need a new cruise control stick on the steering column.

Dec 06, 2008 | 1999 Volvo S80

Not finding what you are looking for?
1997 Plymouth Voyager Logo

Related Topics:

435 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

Marvin
Marvin

Level 3 Expert

83850 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...