Question about 1996 Chevrolet Lumina Mini

1 Answer

Where is the fuel filter on Chevrolet Lumina-Sedan?

The engine is a 3.4 and is four door sedan..

Posted by on

  • ahhadf Feb 22, 2009

    Yes, where is it, someone please post. My fuel pump is starting to make a noise and I want to change the fuel filter to see if it helps at all. 

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

Drivers side cross frame rail, approx between the drivers seat back and left (drivers) side rear wheel

Posted on Mar 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

94 Chevy Lumina Euro Sedan , Only stalls if I ease onto the gas as i normally would pulling out or turning. But if I go heavy onto the gas from a stop it helps avoid the stall. Any advice as to what the...


idle air control valve not working properly idle speed too low faulty transmission tcc solenoid both problems will set off check engine light.replace fuel filter and air filter,clean fuel injectors.

Nov 28, 2011 | 1994 Chevrolet Lumina

1 Answer

Replacing driver's side mirror on a 1994 Chevy Lumina sedan


There are screws that hold the door panel on. They are typically located behind the small round plastic covers. If you look at the bottom of the door handle, you will see them. Also on the door lever, there might be a screw. After removing all of the screws, take a flat head screw driver, and gently pry up the panel. There are plastic clips that hold the panel securely to the door. Doing this will pop them out one at a time. Once the door panel is loose, lift it up, and it should come right out. Be sure to disconnect any wiring harness connectors before fully removing.

Mar 24, 2009 | 1991 Chevrolet Lumina

1 Answer

1996 LUMINA REMOTE


turn ignition switch to OFF position , (all power door locks will lock and unlock) . use a fused jumper wire and jump programming connector to ground . see picture , press any button on one transmitter , door locks , fuel door and trunk lid release should activate in about 2 seconds , first transmitter is now programmed , repeat this last step using a 2nd transmitter , if only one transmitter is being used , disconnect jumper wire and test remote(s) . cheers . if procedure is to technical , ask someone mechanically inclined to help .

0fa3df1.jpg

Jan 11, 2009 | 1996 Chevrolet Lumina Mini

1 Answer

Location of cam positioning sensor for 1991 chev lumina 3.1


On your 1992 Chevrolet Lumina-Sedan/Coupe 3.1L MFI OHV , the Crankshaft Position Sensor is located: clearpixel.gif Under hood, passenger side, lower engine area, passenger side of engine block, mounted front of crankshaft pulley

Nov 30, 2008 | 1992 Chevrolet Lumina

1 Answer

Lumina van engine swap


i think you have to change the computer two

Sep 04, 2008 | 1995 Chevrolet Lumina

Not finding what you are looking for?
1996 Chevrolet Lumina Mini Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...