Question about 2003 GMC Sierra 1500
The blower will not shut off I have to pull the fuse to shut it off. the heater works fine.
I had the same problem. depends what kind of trim model you have. but if you look on the passenger side floor right under the glove box is where your heater unit is. if you take off the cover to it. their will be a little squarebox looking thing with 2 - 3 wires coming out of it and goin to the blower motor unit . Tap the square box with a screwdriver while your blower motor is on off mode. it should shut off if you give it a couple good solid taps. dont be afraid to hit it. that little square thing might have to be replaced if it turns off when you hit it. or just may have to be cleaned.
Posted on Jan 05, 2009
Needs a blower motor module. I just replaced the one on mine. About 125 dollars.Located on the pasenger side under the glove box. Remove the kick plate, two screws you will see a square module unit. It is held in place with two screws also. Two wire connectors to unhook. It took about 20 minutes to replace once I located it. Hope this helps.
Posted on Jan 08, 2009
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
My 2003 Sierra's blower came on by itself in the garage while I was sleeping and ran the battery completely down. I had to replace the blower switch located under the glove box next to the blower at the bottom of the right corner of the dash. The switch is in front of the blower and held in by two screws. Disconnect the two wire connections. This is a "dealer only" part and cost me 65.00. Also check the wire harness with seven wires connected to it for melted plastic. It will be marked "ABCDEFG". If it has melted, you'll need to replace it. Pay attention when reinstalling either part, that the wires "ABCDEFG" match the switch in that order.
Posted on Jan 17, 2009
Tips for a great answer:
Dec 11, 2015 | 2004 Chevrolet Silverado 3500
Sep 30, 2015 | 2006 GMC Envoy Denali
Jan 27, 2013 | 2003 GMC Sierra 1500
Nov 06, 2011 | 2003 GMC Sierra
Dec 31, 2010 | 2006 GMC Sierra
Oct 05, 2017 | 2000 GMC New Sierra 1500
Apr 25, 2010 | 2005 GMC Sierra
Feb 07, 2010 | 2003 GMC Sierra
Oct 24, 2009 | 2003 GMC Sierra 1500
Dec 22, 2008 | 2003 GMC Sierra
386 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: