Question about Hyundai Motor 2003 Elantra

1 Answer

Heater control switch

On my 2003 hundia elantra the heater will only put out heat on the high setting. need to know how to change control.


Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,280 Answers

To replace the control module, you'll need to remove the front dash facia panel to access the virtical console modules. Four (4) phillips head screws must be removed to pop out the this panel.
heater control switch - 16ad4e6.jpg
def318e.jpg The facia has several 'clips' which pop loose when you pry it out.

cba91a1.jpg As you can see, there are four (4) screws in the environment control module. Reassembly is in reverse order.

Posted on Sep 07, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2011 hundia elantra ran out of fuel and now won't start after putting a few gallons back into it.


May have ruined the fuel pump

Have you not listened for the pump
& checked fuel pressure?

Nov 03, 2014 | Cars & Trucks

1 Answer

The heater on my 2003 s-10 stopped putting out much heat.when it is set to def it will put out warm air when turned to dash air the air is warm foe a second and then turns cool. before the heater would...


Check your temp gauge. If it doesn't move you may want to change the thermostat. Also, if you put on the defrost and your windshield gets foggy you may need to replace your heater core.

Feb 15, 2010 | 2003 Chevrolet S-10

1 Answer

Power windows on 2004 hyundai elantra


Replace the dirver's door master control switch assy.

Jun 08, 2009 | Hyundai Motor 2003 Elantra

2 Answers

2004 elantra heater control only operates at #4 setting


If # 4 is the highest fan setting it might be the resistor pack that controls the fan speeds.For each speed increase the fan switch takes a resistor out of the resistor loop The highest speed is a direct connection to the battery. The switch is usually located very close to the fan since it gets quite hot and needs to be cooled by the fan.It is also generaly accessible from under the hood,but not always.Sometimes it is under the dash Hope this helps.

Dec 08, 2008 | 2004 Hyundai Elantra

1 Answer

No Heat


hi this sounds like the elec operated coolant control valve has failed? common fault on ford models however to confirm this? if you warm engine to normal then turn temp setting to full hot do not put fan on yet! locate the heater hoses from engine to point they go into bulkhead of engine bay? feel each hose for heat ? if one is warm/hot and other much cooler/cold ? then cooler valve is not opening so coolant can flow thro heater matrix inside car understand?? unfortunate;y this valve is not servicable but is easy to change and not too expensive ? its location is normally at point prior to entering car interior and you will find it if you follow heater hoses? it may well be in bay below the grill below w/screen is normally plastic renewal will be apparent when you see it ? hope this helps ? just one point all above is on assumption you have checked radiator coolant level is topped up ?? if not this will also give no heat thro heater ? if very low

Oct 28, 2008 | 1997 Hyundai Elantra

1 Answer

How can i remove and replace the heater/ac flow controller on my 03 elantra?


are u convinced it is a controller issue as this is rare on that vehicale i am more tempted to say that it is a cable problem. Or a door acuator if it is auto temp control

Sep 28, 2008 | Hyundai Motor 2003 Elantra

Not finding what you are looking for?
Hyundai Motor 2003 Elantra Logo

493 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...