Question about 2001 Dodge Dakota
You need to push in on door panel at same time in between the door panel and Handel their is a horse shoe clip you will need a "Mechanics DENTAL PICK! to pull it out to release the crank Handel! most part stores will carry that tool!
Posted on Dec 22, 2008
its not hard guys Take the door trim panel by taking off screws and mirror cover / pull out bottom of door and then sides pull up and outthen take off vapor barrier then look inside of door put tape on glass to hold it up take out bolts on the regulator and exchange it Please rate my response thank you very much
Posted on Feb 02, 2009
on this truck the rear window is glued in with urethane, if I was cutting it out I would use a special power tool designed to do this. I am sorry but this will not be easy with out it, the only thing I could see is you bending and cut the frame off with a scraper and hammer. (bad picture in my mind) might be worth a stop at an auto glass shop and ask them to remove.
Posted on Feb 27, 2009
SOURCE: 2001 dodge dakota crank no start
Just had that problem w/ my 01 Dekota, it was the resistor that used to be mounted on the firewall and easy to get to but that is now mounted low on the back of the engine jammed into a bey tight position. I couldn't get to it myself, so ended up taking it to neighborhood garage. Cost me about $150
Posted on Apr 16, 2009
Posted on May 27, 2009
Tips for a great answer:
Oct 27, 2016 | Dodge Dakota Cars & Trucks
Sep 30, 2015 | 2001 Dodge Durango
Jun 23, 2014 | 2001 Dodge Dakota
May 22, 2011 | 2001 Dodge Dakota
Feb 21, 2011 | 2001 Dodge Dakota
Apr 15, 2009 | Dodge Dakota Cars & Trucks
Mar 07, 2009 | 1999 Dodge Dakota
Feb 27, 2009 | 2001 Dodge Dakota
Jan 22, 2009 | 2001 Dodge Dakota
400 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: