Question about 1991 Chevrolet C1500

1 Answer

Lights I just want to know how all the button on my dash board work there is no manual so need to know how to put on lights without brights and such. Would be great to have a manual not sure where I can get one othter then the dealer. 1991 Chevy C1500 2WD Thank you

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

It is on the turn handle switch either you pull it forward or push it back.

Posted on Dec 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My driver side turn signal only works during the day


just on the dash right....... because your dash lights turned on and it changes the brightness of the dash lights, try rolling the little wheel down on the left and see if there is a change?

on the other hand if the outside blinker light fails to work at night the bulb might be burned out you should check it and the dash light might not work if bulb is burned
just turn on the lights turn on the key and blinker and go look?

Apr 21, 2015 | Cars & Trucks

1 Answer

2004 impala turn signal switch lights up dash


sometimes the dash light brightness adjust switch gets in a bad spot and will cause odd reactions, move the dash board dimmer control up and down a few times and see if problem goes away

Feb 06, 2014 | 2004 Chevrolet Impala

1 Answer

No dash lights when headlights are turned on. Everything works fine on my vehicle EXCEPT today the panel lights don't work. Turn signals, hazard blinker, oil gauge, rpm gauge, speedometer, drive shift...


there is a regulator for the display brightness, you may have it turn'd down or it has stopped working;. it controls the brightness at which the dash lights are. usually has a speedo sign on it. goes up and down. it works with the main light and is conecter to them on the same lighting board if it has gone then a new light swtch control switch will be needed.

Oct 13, 2013 | 2001 Chrysler Town & Country

1 Answer

My dash board lights dont work when i turn my headlights on and ive turned the brightness up and still not working, any solutions? and also, my aftermarket radio doesnt work anymore do these problems...


gday mate,geoff here, seems like you may be right, if the radio has been fitted to another fuse, ie the dash light fuse which may well also run the tail lights, alternitavely the new radio may take more power than the original, usnig higher power for more volume, features. check fuse amperage and corrct, look to see ( if you can ) to see the original wiring hasnt been tampered with, if so correct and try again, best i can do without being there,hope this helps, geoff.

Feb 10, 2012 | 1998 Honda Accord

2 Answers

Where is the fuse for the dash lights . the light are bright with key on. Go dull when the headlights are turned on


That is normal. They go bright because during the daytime the outside light is also bright so the lights compensate for the outside brightness by making your dash lights also bright. When you turn your headlights on it assumes it is nighttime and you don't need to have the brightness to see the dash lights so it compensates for this. If you want them to be dimmer, near the light switch there is a roller button to turn your interior lights on just roll that some and it will either make the dash lights brighter or dimmer.

Dec 09, 2009 | 2006 Honda Accord

1 Answer

My dash board lights just went off.what must be happening


It could be something very simple. You may have bumped the dash board light dimmer switch. It is a small slider switch directly above the rear fog light switch which is directly above the headlight switch. This slide switch will adjust the brightness of your dash board lights or shut them off. If you didn't bump this switch, then this switch may just be bad and need replacing. If everything else works, then it is probably the switch.

Dec 04, 2009 | 1995 Volvo 850

1 Answer

Dash board illumination not bright enough


look on the left of dash for the switch you turn your interior lights on turn it see if your dash light will brighten.turn up enough brighten dash lights. dont turn until it stop or your interior light will stay on.

Apr 13, 2009 | 2000 Chevrolet 2500

3 Answers

Dashboard lights won't come on


Most often the tail lights and dash lights share a single feed and fuse.
Assuming you have checked the fuses (probably marked as tail or courtesy)
If you have good fuse and the head light gives a voltage out while in the 'parking light' position (usually between off and headlights) then you need to start chasing wiring.

Jan 30, 2009 | 1989 GMC Suburban

1 Answer

Headlights went out & dash lights went on brighter


That can be a whole lot of things causing this but first if you have an aftermarket remote starter unhook it first to see if the problem resolves it's self,also there are fuses for the headlights check these,another thing to check is have the alternator check as one that puts out to much voltage will blow fuses and make dash lights really bright,autozone can check these for free anything over 14 volts the alternator regulater has went out .

Jan 04, 2009 | 1997 Jeep Grand Cherokee

Not finding what you are looking for?
1991 Chevrolet C1500 Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...