Question about 1996 Pontiac Sunfire

1 Answer

Idler arm where is idler arm located on 1996 pont sunfire 2.2.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 83 Answers

Dosn`t have one it is rack and pinion system has inner and outer tie rod ends.

Posted on Jan 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Interchange on pontiac transmissions96 4t40e


has to be 96 or 97 chev cavalier,pont. gran prix or another sunfire.

Feb 29, 2012 | 1996 Pontiac Sunfire

2 Answers

Valve lash procedure


i need to know how to adjust the valves on 02 pont sunfire

Nov 20, 2011 | 1991 Chevrolet K1500

1 Answer

I have a 2000 gmc Jimmy . I'm going to change the


Locate the idler pulley to the left of the crankshaft pulley. The idler pulley bolts to the idler arm. The idler pulley is replaced with the arm because they are sold as one unit.

  • 2 Place a 3/8-inch ratchet driver into the square hole on the face of the idler pulley and pull up on the handle. This releases tension on the Sonoma's serpentine belt. Pull the belt off the idler pulley, lower and remove the ratchet handle.
  • 3 Remove the two bolts that secure the idler arm to the engine block using a socket and ratchet, and discard the old idler arm.
  • 4 Place the new idler arm against the engine block and secure it using the socket and ratchet.
  • 5 Put the ratchet driver into the square hole on the new idler pulley, pull up on the handle and place the serpentine belt over the pulley.
  • 6 Lower and remove the ratchet handle.
  • Oct 15, 2011 | 2000 GMC Jimmy

    1 Answer

    1996 Saturn the belt pulley located towards the top of the engine broke. What type of pulley is it - idler or tension? I do all my repairs, is this one I can do and procedure? Can't find anything in...


    if it is attached to a spring loaded arm it is a tension puller, otherwise it is an idler, the idler is known to be an issue, you can unbolt it easy enough but is a bit tricky squeezing it past the wheel well unless you jack up the engine a little bit.bring the old pulley with you when you go for a new one just to be sure they give you the right one.

    Sep 29, 2011 | 1996 Saturn SL

    1 Answer

    I need to know the location od the speed sensor for my 1998 Pont Sunfire 5spd manual tranny


    For 1998 Pontiac Sunfire 2.2L SFI OHV 4cyl the Vehicle Speed Sensor, is located mounted on transmission.

    Good luck.

    Jun 02, 2011 | 1998 Pontiac Sunfire

    1 Answer

    How do I check the transmission fluid?


    In an automatic transmission, the dipstick should be located around back of the engine. You let the engine run to normal operating temp. and you check the fluid level, add as needed. You add through the dipstick tube with a funnel. Hope this helps.

    Jul 17, 2010 | 2004 Pontiac Sunfire

    1 Answer

    How to replace a idler arm and pitman arm need to replace it on my 98 gmc suburban 4x4


    You will need the proper tools to remove them which can be rented at auto parts stores. The pitman arm has to pulled off with an pitman arm puller also have to drop steering box I believe to change it. I know we did on my 1996 Tahoe the idler arm can be seperated with a front end fork also available at parts store. You just drive it between the idler arm and tie rod after removing castle nut and cotter pen.

    Jul 17, 2010 | 1998 GMC Suburban

    1 Answer

    ABS light comes on in a 1996 pontiac sunfire


    usually that means your low on brake fluid, check and add first, also make sure the cap is screwed on and secure. If the light still is on, try shutting off traction control if you have it, drive on some gravel and see if you can hear your brakes winding.
    I have a 99 pont bonneville, abs light was on, fluid was full, took off my front two tires, there is a sensor i cleaned out with contact cleaner, and it worked. hope this helps.

    Jul 15, 2010 | 1996 Pontiac Sunfire

    1 Answer

    Gas smell in oil


    Gas smell in oil happens
    1. when Air/Fuel mixture is too rich
    2. Low compression on your cylinders
    Have this checked by your mechanic as soon as possible.

    Nov 28, 2008 | 1999 Pontiac Sunfire

    1 Answer

    Trying to read error codes 98 pont/sunfire 2.2l


    You can't read the codes this way on 95 and newer cars and light trucks (OBD 2 system), you will have to either go to a Kragen auto where they will do it for free or buy a cheap code reader for about $30-40.

    Oct 23, 2008 | 1998 Pontiac Sunfire

    Not finding what you are looking for?
    1996 Pontiac Sunfire Logo

    Related Topics:

    93 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Pontiac Experts

    yadayada
    yadayada

    Level 3 Expert

    61037 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    6812 Answers

    Are you a Pontiac Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...