How much does it cost to replace the timing chain on Oldsmobile Alero?

SOURCE: 1999 olds alero timing chain

I would not buy that vehicle unless he can prove there is no internal damage to the engine. The repairs on it could exceed the value of the car....

SOURCE: How To Set Timing On A 1999 Oldsmobile Alero

you need a haynes manuals because you got 3 types of engines. you got 3.4 3.1 2.4 engines. you got to different procedures.you got to remove a lots of things to get to timing chain. drain coolant remove alternator + bracket power steering a side air condtioning compressor aside water pump come off. harmonic balancer . then you need a engine lift support engine you got to remove top engine mount. you need a manual .because the 2.4 and the 3.1 3.4 timing marking on cam sprockets is different. also crank sprocket.

SOURCE: 1999 oldsmobile alero the traction and cruise not working

use a scanner to check the abs system . most of the time the abs brakes and traction control system work together. your cruise control . unit has a servo motor .in front right fender well. check the fuse and relay also the cruise control brake release switch. and the brake light switch.if all is good you have a cruise control module problems. dealer ship job.

SOURCE: 1999 olds alero timing belt

2.4L engine dont have timing belt.it has a timing chain.fixing timing chain dont cost much.but the damage that occur when it broke.you probably got bent valves.damage piston heads.you can buy car if they dont charge arm and leg.you can repair timing chain your self for at least .$300.00.you have to buy timing chain.it come in a set.you get timing gears and tensioners.about.$190.00 and .$40.00 for timing cover gasket and seal.dealership going to charge you at least.$600.00 including labor.

Michael Thomas

• 3056 Answers
• Posted on May 27, 2010

SOURCE: When should timing belt be changed?

Hi there:
most manufactures call for timing belt/chains to be replaced approximately every 75,000 to 100,000 miles.
Timing belt replacement can be very difficult if you don't have much experience in that type of repair for the best step by step instructions it would be best too go and get a repair manual from your local parts distributor i would recommend getting a chilton repair manual.
hope this is helpful for you best of luck too you