Question about 1999 Pontiac Sunfire

1 Answer

1999 pontiac sunfire stop lights

We thought that there were more tail lights. We put new bulbs in, but they still don't work. any other suggestions

Posted by on

  • beullaful Feb 03, 2009

    Thank you for the advice. My husband has tried everything. Now he has the wiring so that both tail lights work but the right blinker stops when I put the brakes on.



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 188 Answers

Check fuses, and wire connection. Sometimes your connection will get a film on them. Clean them up with a little piece of mild sandpaper.

Posted on Feb 03, 2009

  • spankie09 Feb 03, 2009

    You still got a bulb out them it does this. Check the bulb again.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Tail lights went out, but break lights still work....what is going on???

Bulbs have 2 filaments in them so that one bulb can do the same as two. One filament runs for brake and turn signals the other for the tail lights. You need a set of 1157 bulbs with the flat plastic ends. If new bulbs don't work you may have a wiring or switch problem, but they die at the same time a lot more than people think

Jan 14, 2011 | 1995 Pontiac Bonneville

1 Answer

99 sunfire no drl and only left highbeam works.replaced the relay and put in new bulbs.low beams work but as soon as i turn on highbeams the right light dosent work

it might the wiring harness. the wiring harness is a common problem for the sunfires. GM nows about this and put out a service bulletin but it is not a recall and is not covered under warranty.

Nov 24, 2010 | 1999 Pontiac Sunfire

1 Answer

1997 Pontiac Sunfire Rear Signal Light not working

If was working before and now it's not, it's probably the bulb.
to get access to the bulb the tail light must be removed.
the fasteners for the tail light are accessable from inside the trunk behind the carpet.

May 22, 2010 | 1997 Pontiac Sunfire

2 Answers

2000 pontiac sunfire how to replace headlight bulb passenger

two clips hold the headlight in place at the top...remove these and the headlamp will move forward enabling you to replace the halogen bulb (9007 at CTC)

Dec 09, 2009 | 1999 Pontiac Sunfire

1 Answer

Left turn signal on dash is on when headlights turn on

check the bulb on the left side of your rear tail light. Try changing the bulb for the tail light. This caused by something crossed on the wiring or putting the wrong bulb in there.

Aug 13, 2009 | 2000 Pontiac Sunfire

1 Answer

I don't know how many brake lights there are on a 1999 pontiac s

NO! You should have one on both sides with the tail lights. It is a combo bulb, I think a 1157.

Dec 21, 2008 | 1999 Pontiac Sunfire

Not finding what you are looking for?
1999 Pontiac Sunfire Logo

Related Topics:

143 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides