Question about 2000 Chevrolet S-10

1 Answer

2000 Chevy s10 will turn over but will not start

Its trying to start, we checked the connections to the spark plugs, they seemed to be fine. we know absolutely nothing about engines, an we dont have the money to pay someone..

Posted by on

  • wiley9190 May 08, 2009

    i have the same truck and if the gas is below 1/4 tank it will do that anlso check to make sure your fuel pump it turnning on

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Try spraying starting fluid in to the intake or a shot of gas (better) it should start. i just went through this last week . fuel pump probaly isnt giving the full 60 psi for cold start.

Posted on Dec 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 GMC s10 4.3 v6 vortec wont start. Turns over but wont start please give all reasons why it wont. Ive replaced fuel filter, spark plugs are fine, fuel pump works,


Check spark at the spark plug by putting a screw driver up the cover hold it close to an earth and get some one to crank it over ,the spark should jump to earth.

Jun 01, 2015 | GMC Cars & Trucks

2 Answers

2000 Chevy S10 has spark but no fuel Pressure


Try 2 jumper wires. Since you found a broken ground wire, you should get under the truck and check them all. You can make them up and install them anywhere, but in this case, particularly to the fuel pump.. Remember, the more modern the car, the less steel there is, and the more important ground wires are. Then run another jumper wire from the positive (+) post on the battery to the fuel pump, and see if that works.
Be blessed.

May 22, 2013 | 2000 Chevrolet S-10

1 Answer

My 99 Chevy s10 blazer is turning over but won't start.. Sometimes all power seems to leave and the dash lights will only flash when I try and start it..starter is fine, battery is brand new, and


It can be your mounting house for your spark plugs how to change it ?how to cheak it ? Well there should be 2 or 3 bolts holding it take the bolts out turn on your truck and remove it like you would if it was a cap in the inside should spin if doesent then thats another problem it wouldn't be your mounting house that will be a snapped little belt in the inside of motor not really sure what's it called. So back to your mounting house disconnect all ur spark plugs only connected to the mounting house ( remember we're they go) then remove the bolts and put the new one

Nov 30, 2012 | 1999 Chevrolet Blazer

1 Answer

Im stummped my 1996 chevy s10 ran just fine one day it stalled on the highway its got fuel spark and good commpresion what sencor could be keeping it from starting


First, charge your battery all the way, Is your check engine light on? How did you determine you have spark and fuel? Did you try starting fluid?

Apr 23, 2012 | 2003 Chevrolet S-10

1 Answer

My 2000 chevy S10 wont start I changed the battery and it ran fine for 2 days now it will turn over but won't start


Check Fuel Pressure. First turn key to on position (without starting) and listen for the fuel pump motor. If no motor sound, your fuel pump is not working. Check fuel pump fuse and relay. If fuel pump works, check for pressure at the fuel rail (schrader valve on fuel rail for pressure testing). If no pressure, or not enough, fuel filter might be clogged or fuel pressure regulator may not be working properly. IF fuel is not the problem, start checking electrical, such as ignition control and proper spark to plugs.

Aug 14, 2010 | 2000 Chevrolet S-10

2 Answers

2000 Chevy S10 starting problem


You don't have a carburator. The last carb was on my 1984 S-10 Blazer,which by the way ,I've had 26 years.
Why are you questioning a professional,who's help you asked for. Sounds like a fuel pump to me.

May 10, 2010 | 2000 Chevrolet S-10

2 Answers

2000 chevy s10 starts fine but dies out when push


Have you changed the fuel filter lately? If not do so. Sounds like fuel restriction. Filter usually on frame rail passenger side. Good luck!

Apr 13, 2010 | 2000 Chevrolet S-10

3 Answers

2000 chevy S10 Will not start in the morning , lights radio and all electrical work , after the weather warms up usually after noon the truck starts fine , battery and starter new


The first things to check should be the operation of the choke or cold start.It could be not working properly or out of adjustment.When cold and the key is turned on,you should see the linkages work on the intake of the motor.2nd.Check all fuel filters and lines are all good.3rd.Check the sparkplugs are all in good order.It sometimes only takes one to playup when its very cold and you wont get it going..Try these first and I hope it helps

Oct 04, 2009 | 2000 Chevrolet S-10

1 Answer

2000 Chevy s10 2.2L very rough idle at low rpm


run a fuel pressure test, if that checks out fine it may be a faulty coil pack or ignition control module

Jul 28, 2009 | 2000 Chevrolet S-10

3 Answers

Have 93 chevy s10, stopped and started just fine


the other wire that is "dead" is the ground wire for the fuel pump. try cutting that wire after the connector towards the pump, and running it to a good clean ground.

Jun 15, 2009 | 2000 Chevrolet Blazer

Not finding what you are looking for?
2000 Chevrolet S-10 Logo

298 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...