Question about 2000 Ford Windstar

1 Answer

Truck codes p1132 and p1152 - 2000 Ford Windstar

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 184 Answers

Hi,

P1132 = Lack of Upstream Heated Oxygen Sensor Switch - Sensor Indicates Rich - Bank No. 1
P1152 = Lack of Upstream Heated Oxygen Sensor Switch - Sensor Indicates Rich - Bank No. 2

It sounds to me like the oxygen sensors (between the engine and catalytic converters) should be replaced. Good luck!

Posted on Dec 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford Taurus 2001 3.0L DOCH OBD 2 Code P1132 andP1152


1132: Leaking fuel injector bank 1
- EGR stuck open
- Engine mechanical condition

1152:
Oxygen sensor rich,
Some vehicles built prior to june 8, 2001 may exhibit a cold engine rough idle and / or a malfunction indicator lamp light with diagnostic trouble codes p0171, p0174, p1132, and p1152 in memory.

Aug 12, 2012 | Cars & Trucks

1 Answer

Codes P1132 @ P1152 what are they and where are they?


Upstream (forward most) oxygen sensor bank two (should be the passenger side). On the exhaust pipe close to the engine. You will have one on each side close to the motor and then one further back.

Jul 26, 2012 | 2000 Ford Ranger SuperCab

2 Answers

My 2002 grand marquis is using more gas than normal. auto zone read out listed codes p1132 & p1152 and indicated several probable causes for p1132 -1. leaking fuel injector bank 1, and 2. EGR stuck...


P1132 --Lack of HO2S-11 Switch (Lean)
P1152 -Lack of HO2S-21 Switch (Rich)

You do not guess

You test or try things that do not involve money
or parts

Disconnect & Plug the vacuum hoses to EGR Valve
and test drive

Check for vacuum leaks,including the EVAP System.

You do not have leaking injectors or a bad pressure
regulator.

If you have a vacuum leak it would lean out the
exhaust gases & the O2 Sensor would sense that
& tell the PCM to increase injector pulse width,thus you
go rich,then lean etc.

Stay calm & use logic. No big deal.

If the egr was stuck open it wouldn't idle very well.
Still could be bad.

May 23, 2011 | Mercury Grand Marquis Cars & Trucks

1 Answer

I have a 1998 ford contour that has codes p1130 and p1131 on it what could be the problem. the check engine light is on


H40 DTCs P1131, P1132, P1151 AND P1152: UPSTREAM HO2S NOT SWITCHING. DTC P1130: FUEL SYSTEM NOT SWITCHING AT FUEL TRIM (RICH OR LEAN)
    Diagnostic Trouble Codes (DTCs) P1131 bank 1 (Cylinder 1) and P1151 bank 2 indicate the fuel/air ratio is correcting rich for an overly lean condition. The HO2S voltage is less than 0.45 volt. DTCs P1132 bank 1 (Cylinder 1) and P1152 bank 2 indicate the fuel/air ratio is correcting lean for an overly rich condition. The HO2S voltage is greater than 0.45 volt.
    DTC P1130 and P1150 indicate the fuel control system has reached maximum compensation for a lean or rich condition and the HO2S is not switching.
    DTC/HO2S Reference List
    • HO2S-11 = DTCs P1131, P1132 and P1130
    • HO2S-21 = DTCs P1151, P1152 and P1150
    Possible causes:
    Fuel system
    • Excessive fuel pressure.
    • Leaking fuel injector(s).
    • Leaking fuel pressure regulator.
    • Low fuel pressure or running out of fuel.
    • Contaminated fuel injector(s)
    • Vapor recovery system
    Induction system
    • Air leaks after the MAF.
    • Vacuum leaks (vacuum lines and gaskets).
    • Restricted air inlet.
    • PCV system.
    • Improperly seated engine oil dipstick.
    EGR System
    • Leaking gasket.
    • Stuck open EGR valve.
    • Leaking diaphragm.
    Base engine
    • Oil overfill.
    • Cam timing.
    • Cylinder compression.
    • Exhaust leaks before or near the HO2Ss.
  • Check intake air system for leaks, obstructions and damage.
  • Check air cleaner element, air cleaner housing for blockage.
  • Verify integrity of the PCV system.
  • Check for vacuum leaks.

Feb 12, 2011 | Ford Contour Cars & Trucks

1 Answer

I,have a leak in sidewall,do you think thats way come on check engine light,with p1132 and p1152 error codes.


CODE P1132 LACK OF HO2S SWITCHING HO2S SIGNAL HIGH INPUT. CODE P1152 LACK OF HO2S 21 SWITCHING HO2S SIGNAL HIGH INPUT. LEAKING SIDEWALL ONE POSSIBLE CAUSE IS HIGH FUEL PRESSURE.AND LEAKING FUEL INJECTORS.YOU COULD HAVE FAULTY FUEL RAIL TEMPERATURE PRESSURE SENSOR.

Jan 18, 2011 | 2002 Ford Escape

1 Answer

Have 1998 Mazda 626 with codes: po750,p1131,p1132,p1152,p1652 what do they mean?


These are codes of malfunction of the systems.
P0750 - Shift Solenoid A malfunction
P1131 to P1652 are manufacturer specifics and is a little bit hard to define them with a normal scanner.

Jan 10, 2011 | 1998 Mazda 626

2 Answers

2000 Ford F150 XLT Error Code P1132 and P1152


Error codes P1132 and P1152 indicate O2 sensors reading rich at banks 1 and 2. Change O2 sensors.

Jun 28, 2009 | 2000 Ford Windstar

1 Answer

Check-engine light on


P1132 is front 02 bank 1 and P1152 is front 02 bank 2
This codes indicate a rich condition. I would check for a dirty air filter or a dirty MAF sensor.

Jan 31, 2009 | 2001 Ford Excursion

Not finding what you are looking for?
2000 Ford Windstar Logo

Related Topics:

1,380 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...